Visonik V2208 Car Audio Amplifier - Answered Questions & Fixed issues

You can probably find screws with the right thread at a hardware store.

Hiya, unfortunately the outputs on the amp are probably blown, especially if this happened with the volume cranked up. Will have to go to someone with electronics experience to repair

disconnect speaker,turn gain down to about 10%.repower amp check and see if protection light comes on.if it does recheck power,remote,ground,if it doesent go into protection then kill power and rewire speakers

This usually involves removing the plastic bezel around the stereo. Sometimes these plastic bezels hold some buttons for air conditioning and heat, as well as the hazard lights button. These plastic bezels usually are just snapped in with metal clips on the back of them. You can pry them outward and with a good yank they will pop out. Once you have the plastic bezel around the radio removed, there will be 2-4 screws on the sides, or top and bottom. Once you remove those, the whole radio will pull right out of the dash. Then you have to un-clip the wire harness from the car, and unplug the antenna cable. If you plan on putting a different stereo in the car, KEEP the mounting bracket around the stereo, as well as the "wiring harness" that was used to plug into the vehicle harness. That will save you about $50 in parts to put a new stereo in.

To be absolutely sure of which terminal is positive and which is negative, we will use a 1.5 v battery to have the speaker react as though it is playing music.

* special note * do not use any more than 1.5 v as it may damage the speaker coil

As we know, batteries are marked positive, negative, or both ... we will use this to our advantage when hooking up the battery to our speaker.

To start the process, temporarily attach a short piece of wire to each terminal of the speaker (be sure to either use wire that is marked, or wire of differing colours to help determine which terminal is which). In our example, we used standard speaker wire which is "polarized" (one wire is made of copper and the other is made from tin .. interestingly, this serves no electrical purpose)

Once you have connected the wire to your speaker, proceed to briefly touch the free ends of the wire to the battery terminals (as shown below). In some cases, extended contact with the battery has caused cancer of the voice coil (ie. blown speaker)

If the speaker moves OUT when the battery is first connected, the battery is connected in proper alignment. Be sure to take note of which wire is connected to the positive terminal of the battery as this is your speaker's positive terminal.

Hello sir hi, the black wire is standard color for ground. if you are wiring a speaker, the wire is really not that sensitive, interchanging the wire only makes the sound drop to about 2%, barely not noticeable.

Hello lilgeiger111,

If you have checked all of the wiring and fuses and the amp does not power up, it's blown.

Hope this helps.

The radio code is a security feature that's meant to deter theft, and it's unique to each vehicle. If you've lost your code, you'll need to contact a Nissan dealership or service center and provide proof of ownership. They should be able to help you retrieve the code. Please do not attempt to use codes from the internet as incorrect attempts may lock your radio.

How to change language to english for Honda Odyssey 2021 Gathers Radio Player

I have the same radio now with no Bluetooth am trying to get Bluetooth on it too without having to buy another radio. Please help.

'make model (what is is)' as first 3 words in all questions. https://www.google.com/search?q=demo+mode+the+code+for+4.91 ..

Unfortunately, no one knows or is telling. Companies rarely state power in RMS because Peak Power is a much more impressive. 1000 watt amp, 200 watts RMS x 2 channels at 8 ohms. Look for a sticker on the unit. https://www.google.com/search?q=Xplore+Amp+5553 ..

As used in 2013 Honda Pilot? https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk01V_jKjIwXe6-iL48YYBgrjQpYLYA%3A1613496601626&ei=GQEsYO3aJZKE5wL38aDoBw&q=gathers+vxm-164vfi+english+manual ..

What is your question? Thank you.

Your code is 1 3 6 3

This https://www.google.com/search?q=epicenter+e12-908d ..

try code 62621.

There are three ways to get the radio code. https://www.fixya.com/support/r29874205-need_vehicle_radio_code ..

This appears to be a South African audio device. This link might work better for you are we are in North America. https://www.google.com/search?q=jebson+stc-1052u+wiring+diagram or look for the Installation Manual. ..

'year make model' of the vehicle is needed in questions like this please? Modern vehicle radios are controlled by the Body control Module (BCM) and are used for broadcasting warning beeps and indicator clickers. The beeps an be as innocuous as "do you know your radio is still on"? It can also be caused by your cellphone pinging local transmitters and receiving a confirmation back, or checking in for emails.

What's that beeping? - noise beeps sounds

Ask MetaFilter https://ask.metafilter.com > Whats-that-beeping Jun 9, 2005 - What's that beeping sound I hear everywhere? It starts with one long beep, then 6-8 short staccato beeps.

Car Radio Beeping: Causes & Solutions

JustAnswer https://www.justanswer.com > Mercedes Repair Aug 26, 2010 - What causes a beeping noise to come over the radio speakers? How can it be made to stop? - Answered by a verified Mercedes Mechanic. 1 answer · Top answer: Chat Conversation Started Pete : Hello,I will be glad to try and assist you with this,Welcome ... Missing: periodic ‎' Show results with: periodic

Why is my speaker repeating a single sound of a busy ...

iFixit https://www.ifixit.com > Answers > View > Why+is+m... Apr 6, 2019 - My speaker has suddenly began making a single sound every few seconds which sounds like a single busy signal on a phone. I have read the manual, ... 11 answers · Top answer: It's low on battery. Plug it in!

2015 silverado speaker beeping issue. - GMC Truck Forum

gmfullsize.com https://www.gmfullsize.com > ... > Audio & Electronics Dec 30, 2015 - Sounds like a bad radio since it has moved on its own. Probably set a code for that speaker unplugged too. haha. ibanender said: If it didn't ... ..