20 Most Recent AOpen DUW1616/ARR DVD RW Dual Layer Burner Questions & Answers


Can you hear the motor running when you press the eject button? If yes then you need to change the drive belt.
Open the RW Drive's cover and locate a belt, which connects the two pulleys, from motor to tray gear. It is usually at the front below the tray. Replace this belt and your trouble will be gone.
If there is no belt inside, then you can apply some grease on the gearing.
This is my personal repair procedure and works always.
However, if the motor is not running the problem cannot be repaired at home.
If you cannot follow my instructions, then take it to the service center for the technician to perform repairs. Its low cost and quick.
Remember: dismantling the drive will void the warranty.
Thank you.

AOpen... • Answered on Dec 20, 2012


Look on the front of the tray where the eject button is There should be a small round hole, this is for ejecting a stuck disk. Just open out a paper clip and insert in to the hole and press until the tray opens.

AOpen... • Answered on Feb 04, 2012


Can't you just push an opened out paper clip in to the eject hole on the front of the tray cover. It should be just above the eject button.

AOpen... • Answered on Feb 04, 2012


yes it will

AOpen... • Answered on Jan 18, 2011


Have you checked how the drive is listed in device manager? You may need to find the Firmware for your model of drive and Flash it. This usually isn't as hard or scary as it sounds. :)

AOpen... • Answered on Jul 17, 2010


if u got a cd with ur DVD RW u neet to install the drivers and then reboot the pc

AOpen... • Answered on Jun 24, 2008


Hi,
Try swapping the Jumper block ( Small plastic pin connector ) on The Back Of the DVD Drive. If using both Hard-Drive And DVD Drive on the Same IDE Cable. The DVD Should be set as Master And Hard-Drive As Slave, Or Vice versa.
Failing This, put The Hard Drive On Primary IDE Channel, And DVD On Secondary Channel.
These suggestions, have been made as it appears from your problem listed, that the 2 drives Are Conflicting with each Other.
Finally, is to try a different 4 pin ( Molex ) power cable to either device/Drive. if you have a single rail Power supply unit. the 2 units sharing a joint power cable, may be draining the PSU.

Hope this helps.

Mike @ compurepair.

AOpen... • Answered on May 11, 2008


If it is a combo drive then you cannot burn DVD's with it.
A combo drive can burn CD's and play DVD's

If it is a burner, then install Nero and burn DVD's with that. But as above, if it says it's a COMBO drive, then it can't.

AOpen... • Answered on Apr 22, 2008


Is there a floppy disk in the A: drive? That "port" is usually reserved for a floppy disk, either 3.5 or 5.25in. You probably need to disable the floppy drive in the BIOS.

AOpen Computers... • Answered on Jan 25, 2018


CHECK THE ELECTRICS IS PSU WORKING ?

AOpen Computers... • Answered on Jun 01, 2015


I am assuming that you are replacing or installing a new mobo. You need to read the manual to see if it has an option for speakers, most do. You need to look the details for the "front panel" where you connect wires for power, hard disk lights etc.

AOpen Computers... • Answered on Feb 24, 2015


You can go to the link below and enter the board name is a MX4GER and that will give you your manuals Download Center

AOpen Computers... • Answered on Feb 19, 2015

Not finding what you are looking for?
AOpen DUW1616/ARR DVD RW Dual Layer Burner Logo

11 questions posted

Ask a Question

Usually answered in minutes!

Top AOpen Computers & Internet Experts

Lee Hodgson
Lee Hodgson

Level 3 Expert

4810 Answers

Gustavo Ortiz
Gustavo Ortiz

Level 3 Expert

637 Answers

Cindy Wells

Level 3 Expert

6255 Answers

Are you an AOpen Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

AOpen Computers & Internet

  • AOpen Computers & Internet

Most Popular Question

read dvd

  • Computers & Internet
Loading...