20 Most Recent
Sony RMT-D206A Remote Control - Page 4 Questions & Answers
Is there a solution to update my LG 55G2-UG HDMI port to comply with an HDCP error between my tv and my Sony Receiver STR-DH590?
HDCP 2.2 wasn't released until 2014. The LG 55G2 was released in 2012. There's no way to upgrade the TV, unless you replace it. Using a splitter probably wouldn't help. The device sending the HDCP check needs every part of the HDMI cable daisy-chain system to send back a "Yes I understand" message in 20ms.
Since a receiver isn't usually sending copy-protected video, this message is coming from one of the devices. Reset the resolution for that device to 1080p. Based on your description of the problem, you need to change the video output on the cable box. This depends on the cable box model and the guide it uses. However, either turn off the receiver with the cable box and TV left on. Alternatively, connect the cable box to the TV directly. For some, you then press Menu (for the cable box) twice to get to general settings. Then enter the audio/video section and look for the video output formats. See https://www.spectrum.net/support/tv/hdtv-picture-formats for some of the reset steps. In some cases, you may need to use a different video output to the TV to get a picture, instead of the error message, to access the menu at all.
On my set-top box, I sometimes connect the RF output to the RF on the TV when the set-top box sends a "out of range" signal. I set the TV to channel 3 (in my case) and then reset the video format. Other times, I just get the blank screen but the menu still works to reset the output format.
I hope this helps.
Cindy Wells
Sony DVP-CX850D - not loading discs properly
I am guessing that your DVD player could be broken and the laser part that reads the disc's is also not working too and the disc drive is also broken. The disc drive and everything that is attached to the disc drive needs to be replaced all together.
My Sony TV remote control is not working at all
It could be that the board inside of the remote where the buttons are attached to are dirty and need to be cleaned with qutips and rubbing alcohol or there is a problem with it's infared sensor on the remote or on the TV it's self or pairing problems or if the remote was damaged then. In those cases I would buy another remote for your TV.
XBR65A1E Sony OLED TV. What causes black screen?
I would try and unplug the TV and all of the attachments that are connected to your TV and wait for a few minutes to plug everything back in again and see if that fixes the problem. It could be an issue with your TV's mainboard or a power supply issue.
Five red blinks in Sony LED TV KDL 40W900A.
5 red flashes is a bad panel connection or internal panel short, very carefully take the panel connectors off and reseat them and see if that helps, unfortunately you may have a bad panel.
Not finding what you are looking for?
