20 Most Recent
- Page 7 Questions & Answers
Need to replace the fan in the upper compartment.
you must try from insyde, all my model's have acces from inside. you dont have a seal, remove carrefuly to not bent somethig and it will be ok. I presume that fan is an tangetial fan (that kind of fan have all my wine cooler's) you will need a screwdriver phillips and maybe a wrench.
on Feb 21, 2010
the mildewing is becouse its to damp there and it needs a lot more air to shift this damp away,,,i found the best thing to get rid of mildew is to wash every thing down using a strong mix of white vinegar,,, it works realy well on the inside of wooden boats??
its cheep too, it just smells like a chip shop for a day or so but it will work
on Feb 19, 2010
Recently I moved my Danby
Thanks for using FixYa. To reset the unit you’ll need to switch it off, unplug
the switch from the power socket and mains and let it off at least 8-10 hours
to resolve the issue. If still the issue persists and as you are able to hear
the compressor and fan working you’ll need to check that there is no leakage in
the system. The top fan will only function when it’s too cold and the heater is
in on position.
Please do accept the solution if the issue is resolved or
else revert for further assistance.
on Dec 22, 2009
Noisy Wine Fridge
The problem is likely with one of the two fans. A new fan is available from Danby (1-800-263-2629). My noisy fan is the condensor fan located at the bottom rear of the device. After removing the cooler from under the cabinet, the source of the noise was obvious. You will need to tell them whether it is the upper fan or lower fan. Leave the cooler upright for a few hours before you plug it in so that you do not damage the condenser. Price for the fan from Danby is $20.15 including shipping. Users Manual is available at http://www.danby.com/manuals/DWC512BL.pdf
on Jun 13, 2009
DWC283BLS Wine Cooler running hot, won't cool properly
YOU MIGHT HAVE A FAULTY COMPRESSOR (MOTOR) OR A GAS LEAK.LET ME NO IF YOU NEED FUTHER ASSISTANCE ALSO THE VENTALATION COULD CAUSE IT AS YOU SAY THAT IT IS BUILT INTO THE CABINITS SO REMOVE IT
If the motor are running the gas level are too low . if the motor are not running check the thermostat. if there are power by the motor and stil not running then it is the motor
Does the compressor run or shut off when it gets to 55 &57? Leave unplugged over night and try again..
Also a dusty coils could cause the problem . its very important to keep the coils clean
on May 31, 2009
Not finding what you are looking for?