KitchenAid KSB5CR Chrome 5 Speed Blender - Answered Questions & Fixed issues
Blender won't work
This indicates an internal problem with the blender itself as pertaining to the motor. I would suggest contacting Kitchenaid Customer Service to see about having the blender repaired or possibly replaced.
Their toll-free phone number is 1-800-541-6390.
Also, a listing of Kitchenaid certified repair facilities may be found at the following link:
http://caservice.kitchenaid.com/
7/8/2009 1:32:11 AM •
KitchenAid...
•
Answered
on Jul 08, 2009
•
960 views
Why does Kitchenaid blender KSB655 have burning smell during operation?
If it is not something to do with the coupling (rubber one on the jug bottom and hard plastic one on top of the motor) then I'd be checking that the cutter shaft is not getting hot. If it was the motor playing up normally they pop into error and stop with flashing lights. The switch panels give very little trouble.
1/18/2018 4:44:28 AM •
KitchenAid...
•
Answered
on Jan 18, 2018
•
922 views
My kitchenmaid pitcher is stuck on the mixer. it still mixes, it won;t detach
The coupling on the motor has become bonded to the coupling on the beaker. Maybe it was moving about excessively and the 2 plastic parts have fused together. You can expect to have to replace the motor coupling and at the least the blade assembly or possibly the whole beaker depending on model. Knowing what you are up for needing to replace now if you wish to get it off put a litre of water in it, put the lid on and turn it on high and wobble, wriggle it about until it is able to be lifted off.
8/30/2016 8:22:11 AM •
KitchenAid...
•
Answered
on Aug 30, 2016
•
591 views
How do I remove the motor on kitchenaid Diamond blender, removing the coupler?
Put the base back on, determine which way the motor normally turns from the top when running. Drill a hole in the edge flange of the driving coupling. Stick a punch or screwdriver in the hole and whack the punch with a decent hammer to shock the coupling in the direction it normally will be turning. Sometimes it's a few whacks, sometimes a whole lot more but eventually they always come undone. Replace the coupling.
5/31/2016 6:17:11 AM •
KitchenAid...
•
Answered
on May 31, 2016
•
656 views
Where is located the fuse on kitchenaid blender motor?
dont normally have a fuse
self insulated plugs for safety
fault is either the plug, motor or switch
with a continuity test light or meter
you need to check there is a constant circuit at the two plug prongs
5/27/2016 11:33:48 PM •
KitchenAid...
•
Answered
on May 27, 2016
•
960 views
How do I check for power to motor?
If you have to ask how to do it then there is a good chance that you will not have the equipment to do the check and if you do have a meter you will be electrically unsafe doing it. For starters you need a multi meter, disconnect the motor from the speed control pcb and check it for a circuit. It is more likely that the motor or pcb will be faulty, cable faults on blenders are very rare but now you have your meter you can disconnect the cable from the pcb and check each wire for a circuit.
1/24/2016 6:06:51 AM •
KitchenAid...
•
Answered
on Jan 24, 2016
•
179 views
Not finding what you are looking for?