20 Most Recent Sony CDX-GT300 CD Player - Page 4 Questions & Answers

To properly hook up your 1000 watt Sony Xplod Amp with one subwoofer to your Sony MP-40, you will need to connect the subwoofer to the amplifier using RCA cables. Once the subwoofer is connected, you will then need to use a power cable to connect the amplifier to your Sony MP-40. Make sure the power cable is connected properly and that the amplifier is turned on. After that, you should be able to adjust the settings on the amplifier to get the desired sound from the subwoofer.

Hi, usually one uses a power cycle in order to reset the radio. If the radio is not coming on, the wires powering it could be bad so you'd want to check them with a multimeter for current. Then, you'd want to test the car battery to see if it's still powerful enough to support all of the devices in your car. Then you can get the radio checked. Thank you.

Resistors (loudspeakers of equal resistance) in parallel ... divide the resistance by 2. Answer to your question is yes, you will have 2 Ohms.

Did you do anything around the rear window glass? That is where the aerial is unless you have some other type of antennae. There is also a connector plug under the dash behind the radio. Your signal isn't strong enough for some reason. Have you tried switching between FM and AM channels.

2007 Hyundai Santa Fe Stereo Wiring (the12volt.com)

check out the videos https://www.google.com/search?q=car+audio%2C+wiring+amp+and+subs Manual and wiring https://www.sony.com/electronics/support/res/manuals/W001/W0012780M.pdf ..

your problem could be in the fact that you are trying to overdrive the amp. sony will not carry a 1 ohm stable load and if your speaker are 4 ohm speakers wired in series then you cant drive the bass your looking for. try using soundstream tarantula amp or new hifonics block mono class d amp with about 1000 watts rms. what kicker subs do you have? that will also make the difference in amp choice. im running tarantula on 4 polk momo 4 ohm 12's and has broke my back glass in my jeep twice one time was for a show. oh well let me know. happy boom boom. i'll be glad to help

Take a cotton swab with rubbing alcohol and clean each button thoroughly to remove any residue. There is a eject lever on the device that could be out of place. To fix this some minor repair will be needed. Taking the face plate off using the small button on the lower left hand side will give you access to the reset button. Try this before opening up your entire device. Try any above of these Hope it helps you Good luck

dsfdsfsd

Same question?

aerial is disconnected on the rear or at the rear/front window elements.

Connect one voice coil to one channel of the amp. Repeat with the other voice coil. Do not bridge the amp as your only choices would be series which would be an 8 ohm final load and cuts the amp power in half or parallel wiring which results in a 2 ohm load and very few Sony amps currently made can handle being bridged to a 2 ohm load.

wire one speaker to left and one to right. Do not be confused by impedance. this will work.

Check here https://freeonlineservicemanual.blogspot.com/2021/07/sound-audio-sound-instrument-manual.html?showComment=1625353857089&m=1#c1718629861852162499

As many as you want up to the ratings of the speaker.

sony ---online search audio shop

Usually the remote connection(s) would be left open or disconnected when there is no remote, leaving only the on-set manual controls.

Screwdriver!

fixya doesnt sell products try manufacturer or online search

Internal fuse has blown. Locate it. Order same. Replace.