Top 20
Sony Xplod XM-554ZR Car Audio Amplifier Questions & Answers
Subs wont turn on
make sure there is correct wattage with the subwoofers and the power supply
12/7/2013 4:22:42 PM •
Sony Xplod...
•
107 views • 0 helpful votes
Amp is staying on protect
i got the same amp they good amps but low watts , at one point in time ur speaker wires touched an fried a fuse in the amp . u got to take it apart an see if u see burn in the bord around the fuses an around the speaker out put hopw this help please vote if it did
7/10/2011 8:00:52 PM •
Sony Xplod...
•
103 views • 0 helpful votes
I have a 1985 Honda
First of all please check if the speakers are connected in phase. That is if all the positive and negative terminals are connected OK. Simple way to check is to turn the fader control first to the rear and then while playing some music with heavy beat ( dance music ) turn the balance to one side. Listen and see if you are getting good bass. Then turn the balance and bring it to the middle ( 0 ), when you do that if the bass is becoming flat-- one of your back speakers are out of phase and canceling bass. If thery are in phase the bass should become full and rich. Do the same by turning the fader to the front and try swinging the balance. If all is Ok , yes you will need an Amplifier to satisfy you. Make sure you buy something that can match the power of the speakers you have installed in the car.
The out of phase syndrome is a very common problem.
6/6/2011 7:55:17 AM •
Sony Xplod...
•
212 views • 1 helpful votes
Unpluged battery while doing some
Hi,
May I know you're email add, I will send to you the copy of the service manual. It has a picture of pin-out of your unit...
Jdvillanueva
5/13/2011 8:07:57 AM •
Sony Xplod...
•
74 views • 0 helpful votes
Is the sony xplod cdx-gt71w
Sure is.
The sony is bridgable as follows:
100W x 4 @ 4 Ohm
100W x 2 + 250W x 1 @ at 4 Ohm
This will allow 2 channels to run 100 watts each @ 4ohms with an additional single channel with 250 watts @ 4 ohms.
The single sub channel is created by bridging channels 3 & 4
12/22/2010 5:24:56 AM •
Sony Xplod...
•
213 views • 0 helpful votes
My stereo is installed outside in my BBQ island.
If water did get into the cover of it the circuit board may have got condensation inside and on it. There is no way to tell if there is condensation is to look inside the amp and inspect the circuit board. Also I would not run power through it because if there is condensation on the circuit board you will fry the components.
12/23/2010 10:25:55 PM •
Sony Xplod...
•
158 views • 0 helpful votes
I completely disconnected my amp and then hooked
you may have already blown the amp...if it is doing this with no speakers hooked up to it trace your power and negative line to ensure there are no breaks or kinks in the line...also verify you ohm loads and such and that the amplifier can handle what you are introducing to it( if in fact there are speakers hooked up to it)..as i said b4 however there is a good chance the amp is blown already
My sony xplod 1200 whatt amps red light keeps comi...
check your ohm load on the sub and see if your amp can do the same, That is why every time it shuts off into protection mode. Check your gain level on the amp to this is not a volume knob for your amp, It is to get both the amp and cd player on the same page. Hope this was helpfull
5/19/2010 1:01:21 PM •
Sony Xplod...
•
3,158 views • 1 helpful votes
Not finding what you are looking for?