20 Most Recent Friedrich D50C Dehumidifier - Page 9 Questions & Answers

At 21°C u must have an air flow blockage. It should not freeze up there.

operation at or below 41°F

if it is blowing: room air = no cooling hot air = unit is running cool air = unit is trying to empty sounds like it is NOT hot air

full, too hot, too cold, too dry

what did yo do with the manual?

great question

really? better find a service facility

maybe the new unit is too big for the space. If it is cooling, it is dehumidifying. whenever warm air passes over a cold surface water falls out. IF, however, it cools too fast, it does not take much water out before it is at temp and shuts down.

probably - but I have not heard of a part described like that

float is sticking causing it not to shut off when full

RTFM

how do you know it has energy?

sound like it is out of control to me.

dehumidifiers remove water from the air. They do not defrost anything. If you have frost on the unit coils, it may be because the temp is too low (<40°F) or the unit is defective. unplug it till it melts

this might help https://dehumidifierreviewsandbuyingguide.blogspot.com/2016/09/a-look-inside-desiccant-dehumidifier.html

https://www.manualslib.com/manual/1054413/Swann-Sh3020.html try using a search engine next time - this was the first hit

What is the make, and model number.

i don't know. consider using you vacuum to suck the filter clean. be safe. unplug your machine and use only the least amount of suction to do the job. don't make a hole in the filter. if you do, use a small piece of tape over the hole before turning on your unit.

try a different electrical outlet. turn it on and set it at highest reading then reduce the setting to the lowest. if still not running, unplug it and fiddle with the high level contact or switch on the bucket. seat the bucket properly then plug it back in to test if it works.

i don't know. please make sure your filter is clean. unplug your unit . gently shake giggle and move the float up and down. the switch for the float may not quite be making a firm contact.