Top 20 GE Energy Star WCVH6260F Front Load Washer Questions & Answers

Looks like a programming fault, but try the machine empty if it works correctly Then it was your loading

Put bleach in pocket and wash with no clothes for two loads it sounds like it is stopped up. You may be able to shop vac it and trash back up and out try this first

I would take filter out of drain Pump and check for obstructions. There will be water gushing out when filter is removed, so be prepared.

Check that the Cold water valve faucet is open. Perhaps the earlier vibration problems have caused a wire to come off the water valve connections inside the machine.

Hinges and latching assembly can be purchased if needed. Search Over 2 1 Million Appliance Parts

Check the drum for any Sharpe edges or splits also check the activator for the same . Something in side may have a rough edge to cause this .

what kind of appliance are you talking about

It sounds like the drain pump itself is damaged--the important clue was the humming noise. It could be bound up mechanically or the impeller could be damaged and just vibrating instead of spinning. The part number for the drain pump is WH23X10026. The fact that the pump was humming tells me that the 120v supply is being turned on by the main control board and that the wiring is good all the way to the pump. When I service customers, I try to save the pump if possible in clog cases. Most of the time, they aren't damaged from a simple clog. But, occasionally, the impeller cracks, or the nylon blade gets loose on the shaft, or the motor windings have defects from heat, etc.

You can;t check the board out of the machine. Inside the control panel area should be what GE calls a mini manual and wiring diagram. Should be test procedures in that paper work. It should tell you where to test for voltage if the board is completely dead. If you had power, the board can be put into a test mode to check all the different parts and cycles. Hopefully that sheet of paper is still inside the control panel.

Some GE front load washers go directly into a pump out mode after any power failure (or if plug is pulled). This is to keep it from possibly over filling during a cycle restart.

Might be a leaking solenoid.

Yes you can. If you contact the manufacturer, they will have a kit that has everything you need. If it is under the first year warranty, you will need to use the GE part # for your warranty to not void your warranty.

Sounds like a bad wire or loose connection or bad relay.

May be fabric softener option/ obtain user manual

Chances are this is a bad or faulty gasket. If you call your manufacturer they should be able to point you the the right place to order a replacement gasket.

Probably some bad timer or relay switches.

usually u just pry off the plastic caps then remove the bolts

yes those bolts are meant to be removed or they will hinder the machine from operating

Could be too much detergent. Always had the problem until I was told by repairman only cover the bottom of dispenser with detergent. Don't use the lines they come with. Only need a small amount. A large bottle should last months. Hope this helps.

The water presure switch is open or the door switch is defective