20 Most Recent Intertherm P3RC-030K Air Conditioner - Page 4 Questions & Answers

Best to call Intertherm

Just look inside door and see where filter sits then measure that size

Check your blower motor to see if it's clogged with dust and debris.

Are you sure the limit and sequencer were the problem in the first place? Why replace both? First need to verify you have low voltage getting to the sequencer.

Check to see if fan is running .If not check capicator

Check the flame sensor is clean

try the manufacturer spares first

remove the valve and test the output voltage. sounds like a bad valve

Use whatever you'd like. Match the horsepower and rpm, voltage and shaft size. likely will need a new capacitor too but that depends on what you get.

usually you can find the info you need on the compressor data plate. Not the machine info, the compressor itself

How about high voltage? If you do have high voltage test for continuity on your compressor. If continuity then ohm out compressor, common to start + common to run = start to run!! If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79