20 Most Recent
Galaxy Radios DX-99V 40-Channels Base CB Radio - Page 9 Questions & Answers
What is Ant Radio Service?
https://www.google.com/webhp?
It is a radio station especially for Ant Colonies.
ANT Radio Service
is a system service
that was pre-installed by your device manufacturer or added as part of an Android update by your carrier and smartphone manufacturer* to allow the built-in ANT
communication hardware already present in your mobile device to operate. ... See ANT+
in Mobile Devices for more info.
ANT Radio Service - THIS IS ANT
7/25/2021 3:14:59 PM •
Radio...
•
Answered
on Jul 25, 2021
No power output on usb coba 148 gtl
Check the capicator on the power supply which is only working on the SSB
mode. Many of the 148's had a bad cap installed at the MFG.
Sorry, I don't have the schematics available right now, but it is easy
enough to find.
7/25/2021 1:04:59 AM •
Radio...
•
Answered
on Jul 25, 2021
I have an older style Superstar 3900 that is ''deaf''
in the middle of board. towards the back there is a IC .. that is a preamp, and all the diodes for the RX and the bigger tunning transformers with the big red(sometimes) ferrites are for the RX if cannot figure it out contact me further infomatiion
7/4/2021 6:04:04 PM •
Radio...
•
Answered
on Jul 04, 2021
I have a Blue Parrot
I held the center button for 5 seconds and it repaired by itself. I did not have to go through the resync process.
6/25/2021 2:26:39 AM •
Radio...
•
Answered
on Jun 25, 2021
Will 25 amp power supply pull 250-linear?
Yes it could, but... but it also depends on your antenna, what antenna are you using. Do not upgrade the power of your radio unless you know your antenna can handle the output power.
6/20/2021 12:06:16 PM •
Radio...
•
Answered
on Jun 20, 2021
Motorola BPR40 how to clone
How To Clone a BPR40 Radio
Cloning duplicates the contents of your radio (master radio) into the new radio (slave radio). Tuning and alignment information are not affected by cloning.
Set Up the Master Radio
1. Turn off the radio.
2. Press and hold Programmable Button 1 (the top programmable button) and turn on the radio. Keep pressing the Programmable Button 1 until beep is heard twice.
3. Release Programmable Button 1. Notice the LED changes to RED
Set Up the Slave Radio
1. Turn off the radio.
2. Press and hold Programmable Button 1(the top programmable button) and turn on the radio. Keep pressing Programmable Button 1 until the beep is heard three times.
3. Release Programmable Button 1. Notice that the LED changes to GREEN
BPR40 Radio to Radio Cloning Procedures
1. Connect the cloning cable to both the Master and Slave radio.
2. Press and release Programmable Button 1 of the Slave radio.
3. Within 2 seconds Press and release Programmable Button 1 of the Master radio.
4. The LED for both radios show flashing orange during cloning.
5. Once cloning is completed, an
5/4/2021 5:06:30 PM •
Radio...
•
Answered
on May 04, 2021
Open a yb-500a sandelford safe
I Personally don't think that these should be sold as "safes", but that is a discussion for another thread
5/1/2021 8:06:02 AM •
Radio...
•
Answered
on May 01, 2021
Not finding what you are looking for?
