Maytag Performa LAT2500A - Page 5 - Answered Questions & Fixed issues

Something could be trapped or stuck inside the washing machines drain. Check your washing machines drain to see if something is stuck there.

17 The door / cover switch has not been opened since the last two last revolutions. The door did not open after two complete washing cycles. The door switch has not been opened since the last two revolutions. Displays "od". If the door is open, the error disappears. Check the door lock probably bad. Also you might need to reset it. ... Press power/cancel then start/pause

1. Press power/cancel first.
2. Next, pick a fresh cycle to run.
3. Press start/pause to reset your Maytag washer.
4. Run a test load afterward to confirm that the washer has reset.

Best to you.

Hi, Please power cycle your machine and then rotate the cycle dial by 90 degrees counter clockwise (opposite of usual direction of rotation), then attempt to run a wash cycle again. Otherwise, I would run a rinse cycle and poor some toothpaste in the washer in order to unclog any potential blocks before attempting the wash again. Thank you.

Power unit down by turning off the circuit breaker or unplugging for one (1) minute. Power unit up by reconnecting power. Restart a new cycle. Monitor the washer for one (1) minute to ensure the error code does not display again. Best to you

Holding the Cycle End Signal button for 3 seconds is the way to turn the control lock off and on with this model. If that is not unlocking the control like it should, the first thing you would want to try is unplugging it for 5 minutes to let the controls reset. Best to you

Unplug from the mains. Lower the drain hose into a floor drain or a pail. You should be able to open the door. If not, run another quick wash cycle. The level switch should work now.

Hi, Please reload the washer with dry clothes and attempt to wash them as normal. If the weight is distributed evenly, then the unbalanced-signal should go away once the wash starts. Thank you.

bad control board

possible control timer bad or motor overheating and shutting down

bad timer control board

check belt if ok check cogs under agitator

Hi, Please try clearing sequences by rotating the cycle dial counter-clockwise a bit before starting a new cycle. The reset should then allow your newly chosen cycle to work. Thank you.

Hi, the error relates to a motorspeed sensing error. I would advise you to get the washer serviced via maytag since there are multiple portions breaking down. You can call Maytag to get this done and learn about the actuators potential links to the machine's issues: 1 (800) 344-1274 Thank you.

You will have to call a person that repairs major appliances to have a look and see what the problem is. There could be something wrong with your washing machines controls for the door not to open at all. Or the door latch could be the problem and the motor.

lethang.com.vn

check belt if ok check under agitator for bad cogs

try unplugging to reset if doesnt help possible bad control board or transformer

if knob turned off then bad switch

could have shorted it out or tried running without ground attached might have ruined board

should be a cover to remove then remove bolt