20 Most Recent
Maytag PAV2300 Top Load Washer - Page 2 Questions & Answers
How do you take off the water pump
The drain pump on your model is inside the cabinet on the back left. You can remove the front panel by pressing in on two clips, located in the seam where the front meets the top of the washer,with a putty knife. You will also need to roll off the belt under the washer. Once you have the front panel off the pump is held in place by three screws that anchor it to the washer's base.
It should be part #35-6780 here's a link
Drain Pump 35 6780
Hope that helps!
Washer continuously fills
Not sure if you mean that it fills all the time and overflows or you mean that it just always fills and never has enough water.
The first problem would refer to a faulty water level switch - need to replace.
The second would be that the washer drains as it fills - if the drain hose is lower than the washer, inspect the anti-siphon valve.
MY WASHER FILLED UP WITH WATER, BUT THEN IT JUST QUIT WORKING.
I believe it is your lid switch. I have replaced 3 this week. If you get me the model number i can tell you for sure. Another thing that caused this is the motor to go bad. Do you smell a burning smell when it is trying to run after the fill up? If not get me the model number and i will get you the part number for the lid switch.
Not finding what you are looking for?