20 Most Recent Panasonic CQ-VD6503U Car DVD Player - Page 4 Questions & Answers

hold the right track button until it resets

I'm afraid you'll have to take the unit out for it sounds as though one of the drive belts has either come loose or fallen off entirely. Let me know how you make out. P.S. sometimes there is a very small hole on the front panel try sticking a straigtned out paper clip in about 1/2 inch, it may release the tray manually.

Go to www.cablestogo.com you'll definately find what you need.

its a seperate unit for it and they never made that why so many people r peaved about it the only reasen alot of people bought it was for the nav and they never produced it i phone panasonic to make sure

DID YOU TRY DISCONNECTING BATTERY TO RESET THE SETTINGS? IT WORKS ON MOST SYSTEMS BUT NOT ALL,....GOOD LUCK

nope

power on and hold the right arrow down till it reset

hello ..simple yes

bright green

I recently left my offroad lights on and drained the battery on my 2008 Wrangler. When I charged the battery my radio was doing the exact same thing as yours. In fact I also tried the reset button and the special code access bypasses. What finally worked was disconnecting the battery for 10 minutes and hooking it back up again. I hope that this works. Don

If you have not already tried resetting unit. Bottom left of unit you should see a small round reset button. Press this small Reset button with a Pen or other pointy object. If this does not work refer to trouble shooting section of Owners manual to see if any of that info may help.
http://service.us.panasonic.com/OPERMANPDF/CQVD6503U-MULTI.PDF

If you need service manual I may be able to help [email protected]

when u see id code there. then u click >> track for few sec then automic right there then u ready to go in.

There other posts all you have to do is hold down the right track button for 10 secs.....then it enters the password. Then immediatly go into user and change it to one you want

I dont have schematic but I know that the lt. green goes to emergency brake switch, I have the blu wire hooked up to my amp remote, orange may be for dimmer when headlights are turned on, blu w/wht. stripe I'm not possitive but I think its for an electric antenna, my cq-vd6503u does not have a pink wire.

Contact manufacture and ask them for a master reset code they will send it to you . Also try reset hold the right track button for sometime .

Ensure you have this cable (Panasonic Car Audio CA-DC300U iPod Connection Cable for Panasonic Car Stereos) or if you are wanting to put a Ipod with video you will need the CA-VDC300U. The cable plugs directly into the back of the radio or to the CYEM-100U expansion module. Once the cable is plugged in and the radio is installed (if you hooked the cable up to the back of the radio) turn your car on so the radio works, when the radio comes on hit your source button that allows you to switch between the DVD player and the radio. You should now see a button that shows your Ipod. This will allow you to control your Ipod through the radio and the cable will ensure you Ipod is always charged. This should work if you have the correct cable...I actually just hooked up my Ipod to the exact same radio today using the CA-VDC300U and the expansion module.

EL RADIO modelo CQ-VD6503U FUNCIONA PERFECTAMENTE POR 10 MINUTOS LUEGO DE ESO APARECE ( SEE YOU) Y SE APAGA TENGO QUE DESCONECTAR EL EQUIPO PARA QUE SE VUELVA A PRENDER .
LE AGRADEZCO DE ANTEMANO SU RESPUESTA GRACIAS

I've sent it to Panasonic Service Center but I've made my decision to buy a new branded indash by JVC. It's good till now but this one doesn't have a touch screen.

I don't have the wiring diagram for panasonic CQ-VD6503U car stereo with DVD and navigational system ready. Could you tell me where I can get one? Can you also tell me if this stereo is also navigation ready? I don't know if need a software cd and if I do could you tell me where I can get it too?

hold the right track button down until it resets