20 Most Recent Soyo DYLT032D 32 in. LCD Television - Page 7 Questions & Answers


Call your manufacturer if you are still under man. war. they can replace/repair the unit for you if not they can give you some referrals. Sounds like your powerboard is going to go out on the unit.

Soyo DYLT032D 32... | Answered on Aug 07, 2009


I have a philips universal remote changed batteries now the codes lost

Soyo DYLT032D 32... | Answered on Aug 06, 2009


Sounds like the Main Mother Board is the problem. Basically, it's the brain inside the TV. Controls and functions is that board's job.
Soyo parts are hard to come by. You can try running the number off the mother board on the internet and maybe a supplier will pop up.
Their Soyo.com web site isn't working. So, I'm thing they maybe out of business.
If you have some electronic experance and if your lucky, the heatsink on the chip processor is the problem.

Soyo DYLT032D 32... | Answered on Aug 05, 2009


The problem is the capacitors on the power supply board. There are two of them, the rating is 220uf - 250v - 105C (M). The back side of the capacitor says V9A PET. You need to remove the board, make sure the capacitor is drained, (you can do this by placing a screwdriver across the posts) Use a soldering iron and remove the capacitors. The only place that has replacement parts is at www.mouser.com, Install them, make sure the polarity is correct, re-solder them back into place. Re-connect the board and it should power back up correctly. Good Luck. Steve

Soyo DYLT032D 32... | Answered on Jul 27, 2009


The problem is the capacitors on the power supply board. There are two of them, the rating is 220uf - 250v - 105C (M). The back side of the capacitor says V9A PET. You need to remove the board, make sure the capacitor is drained, (you can do this by placing a screwdriver across the posts) Use a soldering iron and remove the capacitors. The only place that has replacement parts is at www.mouser.com, Install them, make sure the polarity is correct, re-solder them back into place. Re-connect the board and it should power back up correctly. Good Luck. Steve

Soyo DYLT032D 32... | Answered on Jul 27, 2009


first you have to know witch remote you have there is a 3 button witch has vcr tv and cbl at the top that one there press tv and select at the same time untill the light flashes 3 times release then enter 9-9-1 the pres the tv button untill the tv turns off if you have the newest 5 button remote you will press tv release press and hold setup untill light flash's 3 times then enter 9-9-1 light will flash once entered then press ch+ sevral times untill your tv turns off once tv turns off stop and press setup and that will lock the code inplace i hope that helps

Soyo DYLT032D 32... | Answered on Jul 23, 2009


My charter cable company gave me the following three codes for their universal multi unit remote: 10047, 00600, 00629, 00699. The first one was developed by having the remote search for the code and it worked with my unit (identical to yours). The other two were provided by the cable company. Hope this helps!

Soyo DYLT032D 32... | Answered on Jun 27, 2009


Hi
Theirs no doubt you have a software problem with this set,happens a lot on the sharp range too,the software will need upgrading to the latest one for that model.Go to manufacturers website they may have it their with a "how to"note

Soyo DYLT032D 32... | Answered on Jun 04, 2009


Could the batteries in the remote be dying. Did you try changing them?

Soyo DYLT032D 32... | Answered on May 31, 2009


Hi Friends, Teddux, and Guest, have a correct answer,
The Caps is a 2200uf x 6.3volts, reemplace all caps with this spec.

thz.

Soyo DYLT032D 32... | Answered on May 22, 2009


the screws are already removed the should be plugs little ccircles on the back to remove for a wall mount if not check the tv manual

Soyo DYLT032D 32... | Answered on May 12, 2009


Hello you remove the last four screws on the back of the tv located down at the bottom theres two on each side the stand will slide out...

Soyo DYLT032D 32... | Answered on May 09, 2009


Check the PSU/ power supply unit not the cord. The cord is never the issue in this complex problem. You may have a blown fuse in the PSU if its a IC intergrated circuit then it needs to be looked at by a qualified Tech.. We only can help you without looking at it, hope this helps

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

Soyo DYLT032D 32... | Answered on Apr 22, 2009


I can repair the power supply for you if you like depending on where you live repair is about 150.00 shipping may be a little extra

David
[email protected]

Soyo DYLT032D 32... | Answered on Apr 13, 2009


change your source input to the correct video source you are using

Soyo DYLT032D 32... | Answered on Mar 20, 2009


like to make contact with you on this I have the same problem I think we should form a class action law suit on this if we can get enough people to join us
[email protected] I'm not sure how to do this If you have any suggestion's It would be helpful feel free to contact me on this please keep me informed thank you Bill Hoffman

Soyo DYLT032D 32... | Answered on Mar 10, 2009

Not finding what you are looking for?
Soyo DYLT032D 32 in. LCD Television Logo

190 questions posted

Ask a Question

Usually answered in minutes!

Top Soyo Televison & Video Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Cindy Wells

Level 3 Expert

6220 Answers

Vish Iyer
Vish Iyer

Level 2 Expert

76 Answers

Are you a Soyo Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Soyo Televison & Video

  • Soyo Televison & Video

Most Popular Question

capacitor look like

  • Televison & Video
Loading...