20 Most Recent
Toshiba DKT-2010 Corded Phone - Page 5 Questions & Answers
DKT's wont ring from transfer
put an "H" after the extension in the voicemail, i.e. 200H, you have to put in your #656 #657 codes into the phones to integrate the voicemail. #656 91, ext of voicemail pilot, hold #657 92, ext of voicemail pilot, speed dial button (program one on the phone if it doesnt already have it), enter the number of seconds before the phone should forward to voicemail, i generally do 16, hold. that should fix that!
Toshiba DKT-2010 Msg light
intercom # 409 should clear it, if it doesnt, press the message key and if it rings another phone make sure that phone picks up the handset and answers the call.
Conference calling
press the cnf/trn button dial an extension or an outside line and hit the button again after that call connects.
HOW TO CHANGE THE AUTO LINE SELECTION WHEN PICKING UP HANDSET
Sounds like you have two seperate line groups programmed in the system, Program 32 " Automatic Preference " controls the lines the phone will automatically be connected to when the telephone handset is taken off hook or the Spkr button is used.
Toshbita DKT-2010 main phone message
Hi Matt,
If your voicemail is a Toshiba in-skin and your main greeting is under 991 mailbox then the last message you change before getting out of programming will be the active message so listen carefully to the prompts and make sure that your new message is the active one when leaving programming. Let me know if this helps. ....Mitelmike
How do i edit my speed dials?
Redial, speed dial enter the code(60- 99) for system speed dial
(10- 49) for personal speed dial. enter the phone number or the number you want to program then press redial.
HOLD CALL PROBLEM
I assume you have a strata Dk or Strata CTX you need to call your local dealer unless you have the software program then I can help you.
Extension phones
These has to be programmed to ring your will need to csll your local dealer to come and program these phones to ring.
LCD display
if you go to the phone where the problem press intercom#621 then press the # key then press 1 to erace everything on the screen the press speaker or hangup.
DKT 2020 ST
The phone needs to be fowarded to voice mail. go to the phone press intercom# 604, dial the voice mail extension number , press the speed dial button, enter 16 for time then press redial
Not to sure
pcou card is a trunck card for old toshiba phone system.
Msg button flashing
go to the phone where the light is flashing press intercom #409. you may have to do that more than once. Keep doing it until the light goes out.
If the phone system is a DK 8 orDk16 press intercom 409 this will cancel the message waiting light that could have been cativated by a different extension.
Do you know
Wow, an oldie but a goodie. A DK-424 with 10 button sets....doesn't quite seem right, but the card is a 4-port trunk card (C.O.) without Auto Busy Redial.
Your base cabinet 424 can expand to 16 trunks and 32 phones in that cabinet.
Carl
Ringer
If you are using Call Frwd No Answer use code # 603 or if you are using Call Frwd Busy/NAns use # 604 in the following set up.
Press " Intercom/ PDN " plus above code ( #603 OR #604 )
Enter Destination ( Usually Voicemail Access Code )
Press " Speed Dial "
Enter time delay ( 08 - 60 sec )
Press " Redial "
Time delay is default at 12 sec ( 4 ring cycles )
Not finding what you are looking for?