20 Most Recent
Xerox Phaser 7700 Laser Printer - Page 7 Questions & Answers
What is a engine sensor on a Xerox phaser 7600
Unfortunately, your sensor failure will require a replacement from a Xerox technician. You will have to call Xerox or the company you purchased the equipment from to get this resolved.
best way to describe it would be to compare to a cars engine, if your starter fails to work the engine won't run, same for your Xerox device the sensor tells the engine to run.... :o(
This is a major hardware failure on your device.
Vignette printing problmes on xerox 550
It's a bit since I last saw this problem.
I would need a lot more detail to get to the bottom of your problem.
if you have been able to print out the Vignettes before then you can eliminate software, firmware & print driver.
You might have a problem with the laser units, black/cyan or magenta/yellow, the window underneath could be dirty.
If all this is a bit too daunting then you got to get hold of Xerox.
Sorry,
Goodluck.
What does a second transfer bias roll do
It simply drives the transfer belt which is required to lay the image down on the paper.
Depending on which Xerox product you have would depend on whether a service tech is required to replace one that has failed or whether it is a roller that can be easily replaced by a non tech saavy individual.
I hope this helps...
Phaser 8860 prints only on left side of the paper, leaves perfect image on drum of right side.
Dear
As per your statement the image formation on drum is ok but prints partial on paper.
The image from the drum is picked by ITB (Inter Transfer Belt) which is a thin plastic like material and the paper passes in between the transfer roller and ITB.
If the ITB unit is not properly aligned to the transfer roller or to the drum the problem will occur as you mentioned. Also check the transfer roller and it contact path.
Thanks.
I can't wake my Xerox Phaser 6280 from sleep mode.
The Electronics Module may be faulty but first, unplug the unit from the wall for 30 minutes. Plug it into the wall and see if it completes posting and messages display on screen. Console Panel ZNN (Control Panel) 848K19391
Control Panel (PL1.2.16)
1. Remove the Exit Out Chute (listed below)
Note
Be careful not to drop the Control Panel.
2. Disconnect the Control Panel connector P/J220.
3. Release the 6 hooks securing the Control Panel to the Front Cover
(PL1.2.9).
4. Remove the Control Panel.
P/J220
s6280-181
Exit Chute
Exit Out Chute (PL6.1.1)
1. Remove 2 screws (10 mm, flanged) securing the Exit Out Chute to the
Front Cover.
2. Remove the Exit Out Chute from the Front Cover.
s6280-217
Driver
http://xpdrivers.com/printer/hewlett-packard/laserjet/3020/_5_960.cfm
What does it mean when my printer say output tray is full?
Please specify which model you have for a more complete answer. But the basic answer is that when the paper exits the machine and falls in the bin it hits a paper exit sensor. As the paper piles up it will eventually hit the paper full actuator and then energize the paper full sensor. Check to see that the paper full actuator is intact and not broken or missing.
Fix error code on phaser 5500
That error means wrong toner installed. Are you using OEM toner? If it's not the toner it's the Crum board that recognized the toner, part number 160K95831.
Not finding what you are looking for?