20 Most Recent Maytag MMV4205 Microwave Oven Questions & Answers

1 Answer

Door won't stay shut on a mmv4205BAW maytag

Damaged or defective latch. Repair or replace.

Maytag MMV4205... | Answered on Aug 06, 2019

1 Answer

Where is diode located in microwave oven and do you replace

diode is connected from condenser to earth look to the right side bottom just under fan beware for a nasty shock

Maytag MMV4205... | Answered on Jul 16, 2019

1 Answer

I tried poping some popcorn in a brown paper bag

all microwaves have flame sensors that will cut the power in case of fire, this sensor will most likely have to be replaced. this will require you to drop the m/w and remove the case.

Maytag MMV4205... | Answered on Jul 05, 2018

1 Answer

Hi. I accidentally ran

i personally do not recommend to a consumer to work on microwaves. they retain alot of voltage!
but will refer you here....
http://www.appliancepartspros.com/repair-help/maytag-microwave-mmv4205aaw-repair/mmv4205aaw-wont-start.html

Maytag MMV4205... | Answered on Jan 14, 2018

1 Answer

MMV4205AA Microwave will not turn off

Check for damaged, contaminated door switches/clips.

Maytag MMV4205... | Answered on Dec 17, 2017

1 Answer

My microwave turns on, turntable turns, just won't heat. the microwave is 6 years old. Is it wiser to bring in a repairman or just replace? there is a picture of the microwave by the timer window.

There are 2 fuses inside the cabinet. One is for the clock and turntable. The other is for the high voltage transformer and the microwave module. If this fuse is blown either the transformer is shorted or the module has failed to cause the fuse to blow. Parts and Labor can get close to the cost of a new one, so get an estimate so you can have information to make your decision

Maytag MMV4205... | Answered on Nov 09, 2017

1 Answer

I'm removing a Maytag microwave over stove model

Typically there is a metal mounting plate screwed to the wall and when you take the screws out of the cabinet above it it will tilt forward toward you and then you have to lift it off of some metal tabs that are on the bottom of that mounting plate. Lift up and pull away from the wall and let the cord pull out of the hole in the bottom of the cabinet. Good luck. I usually do that by myself and hook one arm under it and lift it up, but probably better with two people.

Maytag MMV4205... | Answered on Oct 09, 2017

0 Answers

GE Spacemaker JVM 131 Continuous Beep

Maytag MMV4205... | Posted on Jun 16, 2017 | Be the first to answer

0 Answers

New Maytag Microwave MMV4205 making a loud noise when heating

Maytag MMV4205... | Posted on May 14, 2017 | Be the first to answer

1 Answer

The fan turned itself on and won't shut off.

Sounds like the on switch for the fan is fused in the on position. You may need to replace the switch

Maytag MMV4205... | Answered on Oct 07, 2015

1 Answer

How can I set the timer and still use the oven to cook food?

Use kitchen timer not cooking timer, it's written on your oven timer pad. I did that before

Maytag MMV4205... | Answered on Jul 06, 2015

1 Answer

Where is the main fuse located

inside the case

Maytag MMV4205... | Answered on Jun 17, 2015

0 Answers

Where to buy charcoal filters for Maytag microwaves

Maytag MMV4205... | Posted on Apr 24, 2015 | Be the first to answer

0 Answers

Why has my Maytag Microwave stopped working?

Maytag MMV4205... | Posted on Aug 26, 2014 | Be the first to answer

1 Answer

How do I change my MMV4205BAS to vent (recirculate) out of the front vent instead of the top vent.

Paul, if you look on top of the microwave before you install it you will see where the fan is located at the back edge. There should be 2-4 screws that hold it in place. Remove the screws and pull the fan up and out of the microwave and rotate the unit 90 degrees towards the front of the microwave and put it back in and replace the screws. That should be all that you have to do to get it to vent out the front.

Maytag MMV4205... | Answered on Jul 29, 2014

0 Answers