20 Most Recent
JVC TH-C60 System - Page 8 Questions & Answers
I own a JVC UX-G37
Check CP901 (ICP-N10-T) in power the supply board. The normal state is a conductive device, in case of protection, it becames an open circuit. Substitute it by a new one.
5/13/2018 2:47:56 PM •
JVC Audio...
•
Answered
on May 13, 2018
Can I connect a 3.5mm audio cable from my TV to this JVC RX705V receiver?
So if you're trying to amplify the sound coming out of your TV to an amplifier you need to connect the output on the back of your TV on the receiver to the end audio input on the back of your receiver you might need different types of connections on each end but as long as you take the output on the TV and input it into your receiver your receiver will amplify the sound another way you could do it is to go inside the TV and connect two wires off of each of the two wires of each speaker leaving the internal speakers connected and then plug them in to the audio inputs on your receiver also if you're using one of the audio outputs on TV make sure you go into the menu and tell it you're using external speakers Good Luck Chuck
3/28/2018 12:58:58 AM •
JVC Audio...
•
Answered
on Mar 28, 2018
I just installed this unit yesterday and I am
roflmao - I just upgraded my phone from a samsung galaxy s4 and the AT&T tech laughed as he asked me how i managed to keep mine working so long.
you likely need a new phone dude. the easy solution: get a new one.
3/8/2018 11:08:53 AM •
JVC Audio...
•
Answered
on Mar 08, 2018
I have a jvc CA-MXKA6
The click is a relay. The 12 position is obviously past the max you should be applying. Keep it below that and you should be fine. Quite often the 12 or 1 position is the max output for a receiver. It depends on a lot of different factors but in your setup 12 is It.
1/16/2018 5:28:18 AM •
JVC Audio...
•
Answered
on Jan 16, 2018
Not finding what you are looking for?