20 Most Recent LG TROMM WM2688H 4.0 cu.ft. Front Loading SteamWasher - Page 3 Questions & Answers

check pump for blockage

ie is the inlet error. Either your water is off or frozen or your valve is bad.

how do i get the inlet valves connected the washer off?

If the washer won't start, the user control and display board or the main control board may be defective. The main control board failure is not common. Check other parts and causes first. If there is power to the display and the machine wont start, check that the door is latching properly as there is a switch in the door latch that tells the control board when the door is properly closed. The switch might be faulty.

bad drum bearing, bad drum teflon pads or both possibly

I would check to see if I put belt on right. There is a belt switch the must engaged. Also is the door switch plugged back in?

If the washer is leaking water the front door boot seal might have a tear or rip and is letting water leak past. The boot seal can be replaced. This part can tear when the washer is overloaded. This is common repair. Manufacturer Part Number 4986ER0004G

panel fault (elecronic board fault) or stucked

There is a small tab that one has to press down to unlock the retainer clip. Press this down while pulling the tray outward.

If it's not leaking outside I wouldn't worry

bpkaplan - did you find a solutiion? I have the exact same problem with my LG Tromm WM2477HW front load washing machine. It is about 2 1/2 years old.

google this code

With a digital volt meter you need to measure the ohms value of the hall sensor. It has 4 wires. White red blue and gray. With the meter set at 20k ohms check hall sensor at the control panel. From white to blue you should read 9.5 K ohms. Same with white to red. If u get 9.5k ohms on both readings u have a bad main board. However to me I think your pump is bad. LG washers will not spin if they don't drain.

Open the soap dispenser drawer and press the green drawer retainer (in the middle compartment) down while pulling the drawer outwards, this will release the catch on the drawer.

The IE or water inlet error or fault code is to indicate that the washer is not filling with water. Check to be sure the water supply valves are open. Also, check to be sure the water supply hoses aren't kinked or clogged. Next, remove the hoses from the washing machine and run water into a bucket to test the pressure and flow of the water. If all of these check out and you have good water pressure and flow to the machine, you should replace the water inlet valve.

When cleaning the filter you may have dislodged the o-ring seal on the filter unit. Check the condition of the seal or if missing replace it with a new one.

Check the hoses for kinks or blockages, if all is fine check the water pump belt for condition and finally check the water pump itself.