20 Most Recent Konica Minolta bizhub C250 All-In-One Laser Printer Questions & Answers


Hi there.
Please try .
Try this.
The error code c3451 refers to a copier warm up error; the machine had not reached the correct temp within a specific time.

I bet it happened when you first switched on one morning.
Easy to reset and fault usually goes away.

To Reset switch machine off using the switch inside the front door, not the one on the control panel.
Whilst holding the UTILITY key down on the control panel switch the machine back on keeping the UTILITY key held down. Eventually a Trouble reset key will be displayed in the LCD screen, touch this, OK will be displayed then power the machine off and then back on.

This will reset the error code, if the code reoccurs then there will be a problem with the fuser unit in the machine, and this will requir
e replacing.

Hope it did work for you.

Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.

All The Best: Pineworks

Konica Minolta... • Answered on Oct 19, 2020


My bizhub c25 jams when printing only colored photocopy. How can I resolve it pls.

Konica Minolta... • Answered on Sep 03, 2020


didn't find this code, so dis you read the code correctly and is the model write. you can try troble reset. turn off printer and then on again, holding utility key down. push trouble reset, and reboot again.

Konica Minolta... • Answered on Apr 06, 2020


C-3421 = Fusing heaters trouble
To Reset:
1. Turn OFF the main power switch.
2. Turn main power switch ON while pressing the Utility/Counter key.
3. Touch [Trouble Reset].
4. Check to make sure that [OK] is displayed and the it has been reset.
5. After turning off the main power switch, turn it on again more than 10 seconds after and check if the machine starts correctly.

If error code returns a technician is needed to replace fuser section. Call local dealer with error code and tell them to make sure a tech brings a fuser assembly.

Konica Minolta... • Answered on Oct 28, 2019


It is a fuser error.

Try resetting. To reset a Rank A error follow these steps:

1. Turn OFF the Main Power Switch.
2. Turn Main Power Switch ON while pressing the Utility/Counter key.
3. Touch [Trouble Reset].
4. Check to make sure that [OK] is displayed and the it has been reset.
5. After turning off the Main Power Switch, turn it on again more than 10 seconds after and check if the machine starts correctly.
If the error recurrs then do the following:
1 Check the Fusing Unit for correct installation (whether it is secured in position).
2 Check the Fusing Unit, PWB-M and PU1 for proper connection and correct or change as necessary.
3 Change Fusing Unit
4 Change PWB-M
5 Change PU1

Konica Minolta... • Answered on Sep 25, 2019


To print the transmission report:

1. Press the [Fax/Scan] key to display the Fax mode screen.
2. Touch [FAX Menu].
3. Touch [TX Report] on the Set 1 tab.

4. Select how to output the report, and then touch [Enter].
– Default: The transmission report is printed according to the previously specified method.
– ON: The transmission report is printed with each transmission.
– If TX Fails: The transmission report is printed only if the fax could not be sent.
– OFF: The transmission report is not printed, regardless of the transmission result.

Konica Minolta... • Answered on Aug 26, 2019


this is a waste toner box error the waste toner box could be defective or the full sensor is defective i would start with replacing the waste toner box and clean the sensors on the door with some canned air the waste box and the sensors are located inside the lower front door the instructions on how to remove the waste box are on a label on the inside of the door

Konica Minolta... • Answered on Aug 15, 2019


Go into the PDS settings and change tab from single page to multiple page.

Konica Minolta... • Answered on Jul 25, 2019


c250 have error codes C-xxxx make and model???? Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Konica Minolta... • Answered on Apr 20, 2019


hi piz Error code P9 and P21 appears on screen and when printing or photocopying using color black, blank copies are outputed

Konica Minolta... • Answered on Apr 19, 2019


Abnormally high toner density detected cyan TCR sensor

Konica Minolta... • Answered on Apr 13, 2019


to what????????????? Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Konica Minolta... • Answered on Apr 13, 2019


check The Transfer Belt or it can be the Black Image Unit . (P9 & P21 normally: black Imaging unit) but P21 can also be refered to Transfer Belt). ..

Konica Minolta... • Answered on Apr 11, 2019


was told this message meant Konica have disabled the machine remotely.

Konica Minolta... • Answered on Apr 10, 2019


machine trouble sevice call [c2558] wat a problam in konica minolta bizhub 164 printer

Konica Minolta... • Answered on Mar 19, 2019


Hi this kind of errors how came u should mention frst may ne after you removed the board and then came ? or while working suddnetly came ? please specify

Konica Minolta... • Answered on Feb 07, 2019


Sometimes just open the doors and closing them a few times will work its sensing somethings open ,Make sure all is closed you may have too reinstall drivers. start over read all directions sometimes we get burnt out on trying to get something going give it a break for a bit then try again. could be a firewall or anti virus cause problems to.

Konica Minolta... • Answered on Feb 05, 2019

Not finding what you are looking for?
Konica Minolta bizhub C250 All-In-One Laser Printer Logo

1,254 questions posted

Ask a Question

Usually answered in minutes!

Top Konica Minolta Office Equipment & Supplies Experts

Norman  J Weimar Jr
Norman J Weimar Jr

Level 3 Expert

6960 Answers

carpediemweb

Level 1 Expert

54 Answers

George Mclaughlin

Level 2 Expert

370 Answers

Are you a Konica Minolta Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

bizhub Konica Minolta

  • bizhub Konica Minolta

Most Popular Question

clear error message c 2558 konica

  • Office Equipment & Supplies
Loading...