20 Most Recent Marantz PMD670 Desktop Digital Voice Recorder - Page 7 Questions & Answers

0helpful
1answer

I have a marantz sr-68 receiver and occasionally when playing through Sonos it fails and goes to protected mode. Any suggestions on how to prevent this.

Is the amplifier being overloaded by the speakers, generally if they shut down like this its because the amp can't supply enough power to the speakers or there is an issue with the wires being to light gauge.
2/9/2018 8:49:04 PM • Marantz Audio... • Answered on Feb 09, 2018
0helpful
1answer
0helpful
1answer

I have Marantz SR6003, when I turn on the power the standby light keep on blinking rapidly, any help will be appreciated. Thanks

I'm an authorized service center for Marantz although I mainly work on vintage equipment, according to the manual the code your getting is for speaker impedance imbalance , but if you don't have speakers hooked to it then you have issues with one of the channels output stages, it may not be something you can fix yourself unless you have some fairly advanced electronic skills
2/1/2018 7:46:34 PM • Marantz Audio... • Answered on Feb 01, 2018
0helpful
1answer

Marantz PM7200 Stereo Amplifier: Can a production fault with an amplifier cause it to keep blowing the speaker on one side, while the other side's speaker is fine?

It could be the amplifier but most likely it’s going to be either the connections or a power supply issue. Do you have anything plugged into the same outlet? What type of power strip are you using. The amp will usually go into a protect mode as to not damage anything before it would create the environment to cause a blown speaker. I know that with your model, along with multiple others, have had issues with the power board needing replacement.
1/13/2018 2:11:45 PM • Marantz Audio... • Answered on Jan 13, 2018
0helpful
1answer

I Have a Marantz CD48. I have replaced the laser unit. But CD is still not spinning and cd is not being read.

Check power plug wires and replace the fuse and check if the unit has fuse on the rear and replace it.
1/11/2018 11:16:05 PM • Marantz Audio... • Answered on Jan 11, 2018
0helpful
1answer

Pm 7000 marantz cuts out when I turn up the volume. Works well at lower volumes... tried other speakers and no issue? Is there a way to check the receiver itself?

If the device works on other speakers then it is probably working as it should. You need to check if the is an issue with the speakers that cause it to cut out. Make certain they are the right Ohms for the Marantz. Check the connections to them. It could be that a safety device is clicking in to protect them amp due to some overload problem, caused by the speakers themselves. It might even be one speaker that is playing up. Try testing one speaker at a time, by not having the other connected and the balance control only to the one connected.
12/30/2017 12:10:44 AM • Marantz Audio... • Answered on Dec 30, 2017
0helpful
2answers

I have a marantz 2325 receiver. When I turn up

http://irebuildmarantz.com/catalog/product_info.php?products_id=34 The symptom you describe could be a failing filter capacitor. It appears to be a common problem with this unit. The above link is a source of replacement parts, and or assistance in getting it repaired. Increasing the volume increases the voltage in the amplifier output circuits, which increases the stress on the filter capacitors. If one is breaking down it could cause a harmonic oscillation that would be a whistle. Hope that helps.
11/25/2017 11:42:38 PM • Marantz Audio... • Answered on Nov 25, 2017
0helpful
1answer

Marantz SR5200 Turns on and off by itself

Thermal cutoff is operating. There is excessive heat being generated on the heat sinks of the Amp. This happens when there is a shorted output transistor or a speaker load changing.
11/9/2017 6:34:54 PM • Marantz Audio... • Answered on Nov 09, 2017
0helpful
1answer

Where can i find a replacement volume control rm0254022 for a marantz 2250b

hi charlie. not sure if this link will help you out,or you could try ebay. replacement volume control rm0254022 for marantz 2250b Google Search
11/2/2017 8:07:21 PM • Marantz Audio... • Answered on Nov 02, 2017
0helpful
1answer

My Marantz AV Surround Receiver SR4200 has an over zealous protect mechanism which turns off the receiver when it's clearly not necessary. Is there any way to adjust or turn off this mechanism?

There are 2 causes of the problem that you describe. One is the input signal is too high and is over driving the amp. The other is the output impedance is dropping due to short circuit etc. There is no adjustment on the protection circuit. It is possible that a weak sensor is present or a bad transistor etc, but you need special equipment to check that. http://www.eserviceinfo.com/downloadsm/40697/Marantz_SR4200.html
10/21/2017 3:18:00 PM • Marantz Audio... • Answered on Oct 21, 2017
0helpful
1answer

Hi for some odd reason my Marantz sr 5006 is completely out of control I can't turn the volume up or down I tried resetting it several times what might be causing this

If it is a twist type knob that regulates the volume control they can often brake so you will need to take it off to inspect it you can do this by pulling it directly towards you ( a small screw driver placed behind it can help to get it off ) then you will be able to check to see if it is broken or not or if you can then control the volume by turning the shaft that the knob was meant to be attached to , a small amount of epoxy glue should fix the knob back onto the shaft if this is the problem .
10/18/2017 11:11:10 AM • Marantz Audio... • Answered on Oct 18, 2017
0helpful
1answer

Marantz sr3001 dolby audio shows no data therefore no sound. How do I correct?

Try download music songs and try again.
10/10/2017 6:01:01 AM • Marantz Audio... • Answered on Oct 10, 2017
0answers

Low output

Be the first to answer 10/7/2017 10:00:04 AM • Marantz Audio... • Posted on Oct 07, 2017Be the first to answer
0helpful
1answer

I have a marantz st100 receiver, and everything

It could be a burned out resistor in the main power amp. Follow the channel wires from the speaker that is playing up till you get to the power amp. Look around for anything odd. Compare it with the other channels, as they are good.
10/3/2017 2:57:12 PM • Marantz Audio... • Answered on Oct 03, 2017
0helpful
1answer

Marantz cd94 mk2 have replaced the belts as they had melted. but i am not getting the drive to spin any suggestions?

Hi. It's nearly four months since you posted this I know. But ive only just seen it. Just wondering if you've got it sorted ?
9/23/2017 2:00:11 PM • Marantz Audio... • Answered on Sep 23, 2017
Not finding what you are looking for?
Marantz PMD670 Desktop Digital Voice Recorder Logo

Popular Tags

32 questions posted

Ask a Question

Usually answered in minutes!

Top Marantz Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

Brad Brown

Level 3 Expert

19187 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Marantz Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Marantz Audio Players & Recorders

  • Marantz Audio Players & Recorders

Most Popular Question

converting voc file wav or mp3

  • Audio Players & Recorders
Loading...