20 Most Recent Jenn-Air 24 in. JDB1090AWS Stainless Steel Built-in Dishwasher Questions & Answers

I took the door apart, removed the control board, which I had expected to replace. I disconnected the ribbon cable that connects the control panel to control board cleaned the connections and reassembled everything. The dishwasher has been working since.

Normally these appliances use brushed steel which gives a stainless steel look.

Get a magnet and run it on the sheet. If it sticks then it definitely is not stainless steel.
However, with wear and tear stainless steel surface does break down causing rust to start.

To remove rust go to this site.

this is usually scale build up and can be remove by using lime away. and run the unit in an empty cycle. there are dishwasher cleaner that can be bought from local parts or home improvement store

Whirlpool parts come with a one year warranty WP owns Jenn Air take it back I have replaced this panel then had to go back and change again in 3 days it failed yes could be a bad batch of panels the panel is powered by the control is the control taking out the panel can't say it is a computer maybe sending to high a voltage to panel no way to test that

Not sure about the rinse agent but the film is caused by hard water.

The problem is hard water. www.dishwasherfilter.com has a product to solve this problem once and for all. It filters the water going into your dishwasher and removes the hard minerals that leave those spots. It is very affordable and even has a money back guarantee. You will love the way your dishes look with this product.

Check the timer control

Replace it depending on how old it is, or unplug for a few hours sometimes this will reset it, hope this helps.