20 Most Recent Whirlpool GBS307PR Electric Single Oven - Page 8 Questions & Answers

Oven temperature sensor most likely has failed.

Try asking the store about it. Maybe it's a privacy setting you need to turn on(or off)

Probably bad bake element

I had that b4 and it was the ribbon cable. Disconnected and reconnected and was clear after 60s reset cycle.

I had similar issue with my electric stove as well. The model of the stove is the same as the one that us mentioned above on the beginning of the this discussion. The issue I had on my stove was that the display shows time and no error code how ever the oven top light indicator comes on but the oven won't heat up. Here are the steps I took to fix the issue: First I unplugged the stove and used a multimeter to verify that it has 240Volt coming. It checked good for 240v. Second, I opened up the terminal on the stove where the plug connects, there I discovered one of the hot leg has melted and broken thus only 120v getting to the stove. I repaired the broken wire and verified 240v coming in the stove and stove was fixed for good. I further investigated what caused the wire to melt and broken, my finding was exposed hot wire shorted to the stove body (ground). Hope this helps. Thanks for reading

use a quality oven cleaner and do it the hard way as the self cleaning is not working

Wiring most likely is incorrect at thermostat or board.

I can try it again

Have you tried to reset it ? If yet then I may be reprogrammed: Whirlpool Oven AKZ430 goes to F03 mode in couple of minutes even after...

You may have a damaged oven control panel. Contact your local utility and file a damage claim

The likely problem is that the oven control panel is burned out.

Fix it because it need repair

Go to this link on the ukwhitegoods forum http://www.ukwhitegoods.co.uk/forumsphpbb3/cooker-oven-forum/switch-whirlpool-generation-2000-oven-t35121.html

This may be due to a partially shorted heating element.

check to see if there is a fuse needs to be replaced any new models or exact same model shud be purchased here>> Procellular Services News Reviews and Deals Online

does it flash or light up if not have the clock by passed and it will go again

dont you mean temp is to low ? First thing is make sure you dont have the temp setting to high the larger the number the colder it gets,note if turned down it will take 24 to 48 hrs to notice any difference. If good then most likely a faulty thermostat

with the on switch for the oven the higher the numbers the hotter the oven the thermostat will do the controlling at the temp you set If that is not happening replace the switch

https://gridology.ru/users/16295

Possible Solutions

Reset power to the product:

There may be a problem with the User Interface or Keypad, the Control, or the associated wiring.

• Power unit down by turning off the circuit breaker(s) for one (1) minute.
• Power unit up by turning on the circuit breaker(s).
• Monitor the oven for one (1) minute to ensure the error code does not display again.
• Verify oven operation.