20 Most Recent Whirlpool GHW9150 Duet Washer Questions & Answers

Hi there
I wonder why, mine does though I never use a fabric softener, the water just runs through. It must be clogged somewhere, the only solution I have is the old one. The needle and the thread,try puting a needle through then pull the thread back and forth.
I hope it works

Whirlpool... | Answered on Mar 21, 2015

Many top load machines have a big metal water level sensor up in the electronics bank with a plastic tube that senses pressure as it fills. There is a small half inch screw in the center of it that is adjustable to set the water level on that thing. The sensor sort of looks like a car EGR vacuum recycler valve. Check Google images of washing machine water level sensors to see if your has it, as it is fairly universal. Make sure your pressure tube is not loose or kinked.

Whirlpool... | Answered on Mar 12, 2014

water pump

Whirlpool... | Answered on Jan 22, 2014

See if the machine will fill up and pump out water. If it does then check the drive belt and brushes on the motor. Hope this helps

Whirlpool... | Answered on Nov 27, 2013

could be control board, in the past this has been an expensive error code to diagnose

Whirlpool... | Answered on Nov 03, 2013

More than likely the washer tub bearing is worn out, this happens due to seal failure and soapy water getting into the bearing, the soap is very corrosive and the bearing fails quickly, this in turn destroys the drum vibration dampers and makes it much worse. The cost to repair this is about $400

Whirlpool... | Answered on Oct 07, 2013

see the cause and fix it. God bless you
f the drain time exceeds 8 minutes, the water valves are turned off and F02 is flashed.

Press PAUSE/CANCEL twice to clear the display.

NOTE: After 4 minutes the "Sud" error will be displayed, then 4 minutes later the F02 error code will be displayed.

Potential Causes

• Check the drain hose and make sure it is not plugged or kinked
• Check the electrical connections at the pump and make sure the pump is running.
Check the drain pump filter for foreign objects
• If the above does not correct the problem replace the pump

Whirlpool... | Answered on Sep 23, 2012


This means that the CCU on the rear of the washer has an electronic glitch. Try unplugging the washer for several minutes if this does not work the CCU would need to be replaced.

To do so remove the top of the washer. Three screws hold it down. The ccu is on the top of the washer. Remove the wires and place on new.

Let me know

Whirlpool... | Answered on Jul 05, 2012

Not finding what you are looking for?
Washing Machines Logo

89 questions posted

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts


Level 3 Expert

85239 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Brad Brown

Level 3 Expert

18564 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

duet Whirlpool

  • duet Whirlpool

Most Popular Question

not rinse

  • Washing Machines