20 Most Recent Pioneer GM-X262 Car Audio Amplifier - Page 9 Questions & Answers

you have buy a fequency converter

you need to get a hml cable that compatable with the unit

you can use a toddle switch and connection to ground;; or u could use a video module from pac;;

yellow-battery red- accessory black-ground blue/white green-+ green/black- {leftrear} purple+ purple/black- {right rear} gray+ gray/what- {right front} white+ white/black-{left front}

you need to check that the mic wire is plug in properly

red--accessories yellow--battery + blk--grnd blue-antenna orange --illumination white + white/blk --} left front gray+ gray/white -} right front green + green/blk -}left rear purple+ purple/blk --}right rear

The flaws of having it connected through Bluetooth. You could always switch to “Do Not Disturb while driving” I use iPhone so that’s how I have it set up.

You’re better off contacting Pioneer Tech Support. It’s hard to diagnose or troubleshoot without having the unit in front of me.

You have to purchase a frequency converter and get properly install

Is it just powering off or is it going into protect mode? If it is just cutting out it may be drawing too much power from your battery. Also, it could be a bad connection or ground.

Power it up and get a pin to stick in the little hole near the disc insert

Since this is a CD player why do you want to add one to it? Try consulting the manual. IF you don't have the manual go to Pioneer and get a copy.

http://support.pioneer.eu/peeservice/instrmanuals.nsf/($$allbyunid)/95D6C753D642D16DC1257CFB0037B1C2/$file/QRB3479_FH-X720BT.pdf

You don't need it. Tape off the end with electrical tape and bundle it up and leave it with the the rest of the bundled up wires from the harness. The radio will light up when the power button on the radio is on.