Pioneer CDJ-100S CD Player - Answered Questions & Fixed issues
2 pioneers cdj 1000mk2 both
Are you using all the space on your cds with those three songs and the CD can only hold 3 and a half songs?
Cd error and ejecting
There is a problem with the motor that ejects the cd out!you start getting those error because you put mest up cds in your cdj!You need to always make sure there clean and not scrtch too bad specially with old cd decks like the 100!
CDJ 100 s PROBLEM E-9103 and E-7201
E-9103 is MECHANICAL TIME OUT,
Solution : some object in compartment slot, remove it, or clean player compartment
E-7201 is disc cant be read in 20 seconds,
Solution : Disc has scratch, Replace disc
Disc is dirty, Clean disc
Dj ajay
[email protected]
Laser step motor dont move
can be varios reason: 1) faulty motor 2) control motor defective 3) lube in shaft motor 4) mechanical device for motor defective.5) Syscom (microcontroller defective) see the block diagram
CD keep ejecting when inserted
99% laser module is faulty.
if u try to push your cd and it returning it or your cd stuck inside and it stating no disk, find a new laser and replace it.
regards
Eu tenho o cdj 100
hello frnd,
can u pls post ur complete problem. what error u get. does cds play or not. how old ur cdj's
thx
No disk runing
This can be caused by a defective laser pickup head, bad pladder motor that turns the disc, or no voltage reaching the motor. In most cases it would involve changing the whole laser pickup assembly or replacing the unit because of cost.
Half an hour ago the
The CD drive in your CDJ is hunting for the disc, i.e it has become difficult for the player to read the disc. Keep your ears next to the loading slot after inserting a CD, you will hear a motor spin up then slow down then spin up again and if this continues the system will lock out the eject function. Or else the disc will come flying out!!. Either you need lens cleaning ( try a cleaning kit ) or replacement ( If the player has crossed over 500 hours of use )
Doesnt read all the cd
Hello
There are two reasons for this trouble. First one is Laser Pickup Unit fault. Second one is the strip wire connected from the Laser Pick Up Unit to the printed circuit board have broken carbon tracks in it. You just replace the strip wire, first, and see if it helps. If not replace the Laser Pickup Unit. Ok
Hi, can advise on the basic procedure in changing
hii,
sorry for late reply, i just saw ur msg here. I have sent u email having pic to micro switch for CDJ. We frequently changes micro switch for Cue button.
i dont know, if u received my email or not.
tx
djajay
Cdj 100s
can u ask ur question in English
Not finding what you are looking for?