AEG SK78800I Compact Refrigerator - Answered Questions & Fixed issues

yes, get a pipe cleaner and put in to the hole to try and clear if not from the back you will find the pipe which will be clipped to a plastic tray on the compressor. unclip and blow up the pipe this will always clear the blockage.

Most likely you're correct, the defrost cycle produces water that is supposed to be captured in a holding tray, pan, etc. If the pan is cracked it would leak out or if the drip tube (pipe) is not in place it would miss the pan. It may be easier to remove the contents of the small frige and tip it over some to see what you can down there. I assume this small unit doesn't have any water souce to it (no ice maker or water). Check the tubing for damage and see if you can find the holding pan to inspect for crackes, etc.

May not be the thermostat. Could be the fan motor.

sorry but only a local repair service can help you

There must be a gas leakage due to which the refrigerator is not cooling. Better call a technician to fix it.

Possibly evaporator fan not working or defrost problem.

Sounds like the drain pan or tube is frozen and clogged You need to shut off the unit and empty the freezer section and check the bottom of the rear wall of the freezer for the drain pan. use sink hot water to defrost and a turkey Baster to clean the hole and the hose.

no gas or faulty compressor not worth repairing

You have very good door-seals, with strong magnets on the refrigerator. I suspect, You must pull hard to open the door. Does the fridge have 2 wheels? It may only stand firm on 2 "legs" and not 4. This problem is the first, I ever heard, I do not know this model, If it is a Refrigerator that is not very heavy, this can happen. When the door seals are very good, what can happen is The door has been closed and the air inside the fridge becomes cooler and cooler. The air inside the food-compartment contracts, because it cools down and pulls even more on the inside of the door surface, actually pulling the door shut. ( a negative air-pressure inside the fridge) compared to the outside of the refrigerator. A trick I am using is, 1.) I place my finger between the door and the cabinet-frame. 2.) Then, with the finger, index or middle finger, I push gently against the Door-Seal (Gasket). for 1 or 2 seconds, This allows the Air from outside, (higher pressure) to flow into the food compartment of the fridge and now it is easy to open the door. Let me know if this works for you. Appreciate to be alive and be kind to others. Klaus (Electrical & Refrigeration Technician) Toowoomba, AUS

The model number is important if you look up the model number example "ABC1234XY01 user manual" Google those words and it should be in there how to reset the water filter light without your specific model number I can't tell you. There's just too many different model numbers to guess on the instructions for that model the model number should be found inside the fresh food compartment around the door Appliance 911 Sea Breeze

in the door

is the fan working blowing? check the door seals and the cold control thermostat. the vent from freezer to fridge.

Return your thermostat to 5 setting. If this does not help, it is probably the contacts inside the thermostat are welded shut and needs to be replaced. You can find you replacement thermostat with your model number on Searspartsdirect.com.

Most likely you have a blocked drain line. Clear the line and the trap and you should be fine.

if you go on line and type in your make and model number it should bring up a supplier who deals in the them or type the make and it should bring up there home page and ask on the site good luck

When power goes on and off suddenly, it can cause the compressor to overload and "trip out" This is supposed to protect the compressor from being electrically damaged. In most cases, after 10 or 15 minutes, the compressor will reset. It is usually safer to switch off the fridge or unplug it for 10 to 15 minutes to ensure a full reset. If it doesn't start, the power surge may have damaged the compressor relay. or overload device on the side of the compressor. I would doubt that it damaged the compressor itself. Be aware of the relay and overload device, unfortunately, there are Techs who will quote for a compressor job when all it needs is a relay or overload.

It is possible that water line to the ice maker is frozen. Try thawing it out with a hair dryer and see if that solves the problem. It could also be the solonoid valve located behind the fridge where the water line connects.Make sure the arm above the ice bin is in the down position.Hope this helps.

Where is the fuse on arctic freezer

Usually this is a symptom of a faulty door seal or a very frequently opened fridge they extra moisture load from the environmental air.