Eiki EIP-2500 Multimedia Projector - Answered Questions & Fixed issues
I have both the stand
The bearing of the colourwheel is locked. No rotation of colourwheel possible, then also no lamp ignition. Colourwheel has to be replaced.
Black line appear when start up
the connector between mainboard and DMD board should be clean.
even the pressure contacts between DMD and its boars should be spotless clean. takes experience to disassemle !!
How to remove top cover of Eiki EIP-2500 projector
loosen all the screws from the bottom ( one is in the middle) and two at the back ( edge)
press the grill on exhaust fans side near the heat warning mark.Lift carefully the rear and turn towards the lens side, BUT BE CAREFULL that some points of the upper cover will not scrape of some smd parts from the mainboard !!
Light stay on
possibly max lamp usage hours have been exceeded
5/4/2016 11:29:19 AM •
Eiki Office...
•
Answered
on May 04, 2016
•
289 views
LC-XNB4MS projector has a yellow
this has soething to do with bad timing of the lcd panels on the prism block. This is a common problem for this model.
You will have to replace the entire optical, which is very costly.
better invest your money in a newer model
4/17/2014 1:04:45 PM •
Eiki Office...
•
Answered
on Apr 17, 2014
•
111 views
I have an eiki lc
this depends on the signal type coming from your sources
best is using component signal ( Y-Pr-Pb) , by using the right cables and right settings for video inputs in the projector menus.In basic this should be possible.
4/17/2014 12:41:41 PM •
Eiki Office...
•
Answered
on Apr 17, 2014
•
120 views
Projector causes buzz in sound
buzz in sound is often caused by ground-loops, try to isolate audio
cables with so called groundloop isolator transformers ( 1:1)
available at high end audio shops or car audio centres
4/17/2014 12:25:14 PM •
Eiki Office...
•
Answered
on Apr 17, 2014
•
125 views
Not finding what you are looking for?