20 Most Recent Asko W6221 Front Load Washer - Page 5 Questions & Answers

ASKO THE DEALER ABOUT IT

The pump may not be working to empty the tub.

Asko dishwasher reset How to Reset an Asko Dishwasher

1. Press the "Start/Stop" button.
2. Hold the button for three seconds and release.
3. Select the program and options on the front panel you want the dishwasher to use. Press "Start/Stop" to restart the dishwasher. You have now reset an Asko dishwasher.

How to Reset an Asko Dishwasher ' Hunker

Some possible help links below. manual link below https://content.abt.com/documents/54957/User_W6424W.pdf One thing I noticed was if machine is in delayed start mode press and hold start/stop button for at least 3 seconds. Manual below says after wash complete press main power switch on control panel. http://content.etilize.com/User-Manual/1014930325.pdf https://www.youtube.com/watch?v=N6wpsRIU1t8

https://www.repairclinic.com

Apparently it is as much as a 16 year old model, and I could not locate instructions for that model, using https www.google.com. There was a site with parts, however, but not a manual.A similar model manual, for W6021, shows controls that may be similar.https://www.manualslib.com/manual/396407/Asko-W6021.html

It could be a faulty water inlet valve, but it could also be a blocked tube between the tub, and the water level pressure switch, because over time, this can become blocked, and affect how much water enters the machine. An easy test is to put the machine on a fill cycle and then turn of the mains power to the machine as the machine begins to fill; if the machine continues to fill, it is probably the water valve; if not, check the tube from the tub to the pressure switch. I hope this helps?

Try another cycle...timer may be going out

If the main PCB is still pulsing the "beeper" even when unplugged, it would be the on board capacitors still charging it. Apart from changing the main PCB, I would suggest you leave it unplugged for as long as necessary to fully power down the capacitors. It will take a few hours or more. Try using the machine when it has stopped beeping. It may then be OK. If not, a board replacement will be the only solution.

Hi Jacqueline,the filter will usually have a rubber o-ring gasket to seal the opening to prevent leaks. When you cleaned it,the gasket may have kinked, torn or popped out of the groove that holds it in place. Open the filter and check if the gasket is in place, if not slide it back into the groove and that should stop it from leaking. Also check the small drain hose, make sure the stopper is in. That should take care of any leaks in that area. If the leak continues I would suggest calling a local repair company. Hope that helps.

you have not provided enough information to even begin troubleshooting. I recommend a repair technician be contacted. This is not a do-it-yourselfer job if you don't have experience.

try turning the tap off at the if unplugging the machine didnt work,i would say you water solenoid is stuck open

The load has become unbalanced. Pause the machine in mid-cycle (do not Stop it) and when it ceases spinning, open it and re-distribute the load evenly. Then press Pause again to continue the cycle. Note: if you Stop it, then restart when finished balancing, the machine will start washing from the beginning instead of continuing from where you Paused it.

Drain pump may be obstructed

Faulty timer by the sound of it.