20 Most Recent Maytag M3X05F2D Air Conditioner - Page 4 Questions & Answers

There is a low freon pressure switch in the system. A small amount of freon will show enough pressure to start the unit. As soon as the compressor starts the low side pressure (where the switch is) drops and shuts the unit off.

You probably don't, Justin. It's probably permanently attached to the upper / outer shell, so you probably have to take the whole shell off the air conditioner to clean it.

Replace gas valve.

If it's blowing very MUCH of it, then it's coming in from outside. There's very little inside an air conditioner that could possibly generate smoke, and VERY little that could possibly generate any LOT of white smoke. Now... it's POSSIBLE, if your humidity is high right now, that it's blowing cold enough air to condense the humidity in the air, causing an actual cloud (just like the ones in the sky) inside your house. That can happen only when the humidity is very high, though.

I suggest that you try turning the unit off, unplugging it, and leaving it turned off for a couple of minutes. Sometimes these appliances can be reset by turning them off, waiting, then turning them back on. It's similar to rebooting a computer when it's hung-up.

Open the door part way until it rests open. Grasp door on side edges with either hand and pull straight up at the angle the door is resting.

There aren't any latches on the Maytag MGR5780 oven door hinges. You should be able to open the door to the first stop (about 4" from the closed position). Then grab the sides of the door and lift the door up at that same angle until the door clears both hinge arms. Manage My Life has the manual for the MGR5780 here: http://www.managemylife.com/mmh/owner_manuals/25316/MAYTAG-Free-Standing,-Gas-L0303326 . See page 15 (16 of the PDF) for a picture of the door open to the first stop position. You will need Adobe Reader or a similar program to read the manual.I hope this helps. Cindy Wells

Sounds like you have a bad compressor, something is either shorted out, or drawing too much power causing your breaker to trip. Is this a window unit, or a ductless unit? I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_54ae41aaaffbab00

Error code H11 - Please help.

bought 2005, worked great, used on limited basis is garage, presentanty no cold air