20 Most Recent Fisher and Paykel Fisher Paykel Intuitive Eco Washer IWL15 - Page 2 Questions & Answers

blocke filter on cold solenoid or faulty solenoid

I BELIEVE THAT IS A ROTOR SENSOR ERROR
REPLACE THE ROTOR SENSOR

If you wired the pump directly with a lead and 230V supply and it works ok, then doesn't work when powered by the control board, I would say that there is a problem with the control board not supplying a full 230V to the pump.

rotory postion sensor is faulty

one of the computer boards is faulty,no way to tell which try one and if not fixed try the other one

Almost impossible for someone out here at the other side of the internet to say when we can't see or test anything. All I can suggest is before you press start the light on top row should be blinking. Now when you press start do you get a beep and the light stops blinking and stays steady? If it does then the most likely problem will be a faulty lid switch. Apart from that I suggest you get a service person out who can look & test for you.

it just needs a bit of crc or similar sprayed on the front and back pivot bushes

under the motor cover there is a small electronic board attached to the motor, thats it

faulty water solenoid

faulty cold water valve, if that doesnt fix it then fault computer board

it a top loader replace the 4 suspension rods

the top ring you describled has small drain holes in it to prevent this check to make sure all of them are not blocked

Sounds like your out of balance switch is corroded. It is located underneath your gold motor controller board.

130. (10000010) Single Rotor Position Sensor Error The Motor Control Module has found an error in the pattern received from the Rotor Position Sensor. Likely causes of this fault are a bad connection on the harness between the Rotor Position Sensor and the Motor Control Module, or a faulty Rotor Position Sensor. Primary Source: Wiring. Action: Check for corrosion on the RAST connector of the Rotor Position Sensor and the Motor Control Module connector. Secondary Source: Rotor Position Sensor. Action: Check the Rotor Position Sensor with an R.P.S. tester. Replace if faulty. Tertiary Source: Motor Control Module. Action: Replace Motor Control Module. Quaternary Source: Rotor Action: Ensure the correct rotor for this phase of machine has been fitted.

Firstly, the model 708 is way more than 9 years old. More like 18 - 19 years old. There is 2 types of errors on a smartdrive. One is signalled by a single beep every second & the top row of lights will change. The 2nd is a rippling musical sound (like when you turn the power on at the wall) and some lights will be blinking. You need to tell us what sound it is and which lights are blinking or which of the top row lights are on (exactly, count from the right to left and which number is on & which is off) There is no such thing as a reset to do. Once I know the fault I can advise you what to do about it.

Error code 56 is mostly the motor controller, SD11 & SD12 brown boards, 3 x 332k resistors near the small transformer go low & need replacing with a 1 meg Ohm resistor will fix the problem.

get the technician back as it appears to be a program board fault --again-- This brand is not entirely reliable and went broke and was bought out by the HAIGER company who make s fridges and washing machines

http://ww2.justanswer.com/uploads/thehomesmithy/2010-12-19_141627_gwl11_iwl12_iwl15_suppliment_togwl03_manual_.pdf here is the manual it has detailed info on your error code 96 decimal is 01100000 binary so look for that.. youll see what i mean when you look at the manual i think its a phase 6 error and looks like something to do with the pump