20 Most Recent Avanti FF1101W Top Freezer Refrigerator - Page 2 Questions & Answers

If any part of the automatic defrosting system isn't working, the evaporator will turn into an iceberg and no cold air will circulate into the lower compartment.

Possible causes in that case could be the defrost timer, the defrost thermostat ("bimetal"), the defrost heater, the defrost thermal fuse (if there is one), or the wiring and plugs connecting them.

Removing the back panel of the freezer compartment should reveal the iceberg and allow you to defrost it with a hair dryer or fan. Then you can get at the parts to test them (except the defrost timer, which may be down by the compressor).

Is not truth than a refrigerant like can?t be repaired I do it almost every day How ever is not like a DIY project If the service man toll you that is may be because is real time consuming and dint want to do it or dint have the proper knowledge skills tools or niter one. Tray a deferent service technician and ask him at front if is willing and able to do it Remember this type of problem is time consuming and most likely you going to have to take the fridge to there shop.

Check to see if your condeser fan is runnig properly you may need a fan motor.

The problem you describe could be caused by a lot of different things. To start with, is the fan in the freezer running?

https://manualsdump.com/en/manuals/avanti-wc1500dss/66172/12 The above has a troubleshooting matrix. Power supply: Check if the wine fridge is receiving power from the mains supply. If it's not, there might be a major issue with the mains power or the PSU circuit board in the product that'll likely need replacing if it's faulty. Condenser fan: The condenser fan is designed to cool the condenser and condenser coil within the Avanti wine cooler. If it doesn't function, the condenser and coil can overheat - causing the internal area of the wine fridge to heat up too. Take a look at the rear of the unit and make sure the condenser fan is spinning freely and not blocked (by dust / dirt) or making excessive noise due debris or a blockage. Thermostat: If the Avanti wine fridge thermostat is working correctly, it's responsible for making the condenser, evaporator, fan, and compressor work - so it's super important! The thermostat also allows you to control and adjust the temperature of the wine cooler so if the reading on thermostat is inaccurate (or flat out wrong) the wine cooler temperature will likely be inaccurate too. Why Is My Avanti Wine Fridge Not Cooling (And How To Fix It) - Expert Wine Storage

If your Avanti WCR683DZD-2 wine cooler's LED panel is blinking when plugged in and neither the fan nor the compressor comes on, there could be a few potential issues. Here are some steps you can take to begin troubleshooting and attempting to repair the unit:

1. Check power supply: Ensure that the wine cooler is receiving power by verifying that the outlet is functioning correctly. Try plugging in another device to confirm if the outlet is working properly.
2. Inspect the power cord: Examine the power cord for any signs of damage or wear. Make sure it is securely plugged into the wine cooler and the power outlet.
3. Check the control board: The blinking LED panel suggests a possible issue with the control board. Inspect the control board for any visible signs of damage, such as burnt components or loose connections. If you are knowledgeable about electronics, you can attempt to repair or replace the control board. Otherwise, it may be best to consult a professional technician or contact Avanti for further assistance.
4. Test the temperature control thermostat: The thermostat controls the operation of the fan and compressor. Using a multimeter, you can check the continuity of the thermostat to determine if it is functioning correctly. If it is faulty, it may need to be replaced.
5. Examine the compressor: Inspect the compressor for any visible issues, such as loose connections or damaged wires. Ensure that it is receiving power and that the compressor motor is not overheating. If the compressor is not running, it may require professional servicing or replacement.

This is Thermoelectric Cooler, so no compressor. Clean around the back where the heatsink and fan is. https://www.manuals.ca/avanti/ewc1201/manual?p=9 Customer Service is on the next page. ..

check the heating element

The single control is what you have to regulate temperature electrically. Variance in temperature is otherwise influenced by how much is contained within (which affects cooling circulation) and how much you keep opening the door. https://settingslab.com/avanti-mini-fridge-settings/

It is probably a K50. https://www.firstchoice-cs.co.uk/ranco-controls/rnck50-p1102

The most likely reason for commercial coolers and fridges not cooling is a low gas state. Did you get your gauges out and check the high and low side pressures before you started swapping parts out?

It is a power supply smd 12 volt 6 A model S 126SMD3 it is craft by www.hanny.com.cn

Drain to freezer, defrost and clean

Usually the vent at the rear of the freezer is blocked with ice. Often caused by a faulty heater or defrost timer. Also check the circulating fan for the fridge. ..

HI David, Please check there: https://manualsbrain.com/en/brands/avanti/fridges/ for a manual. Hope it's helpful

only one and it is " no wine for you"

https://www.manualslib.com/manual/792736/Avanti-Rm3306w.html?page=10

Could be due to control board failure