20 Most Recent
Roper RGS7745PQ Dryer Questions & Answers
Dryer belt config..
Hello,
Watch this youtube video and it will show you exactly how the belt fits on the motor pulley and idler pulley if i were you i would pause the video at the section where its shown how the belt fits around idler/motor
here is the link to that video;
http://youtu.be/CFnXwmUb4f4
Gas dryer belt tensioner, how does it go back on?
I am not familliar with this brand. However, it if is a typical tensioner, there are slots in the floor of the machine and the tensioner fits into them. Look for the slots in the vicinity of the motor pulley.
Thanks for your visit today.
Dryer runs but does not
Hi,
If you are having problems with your gas dryer not heating the most common problem is that the ignitor goes bad. Even though it glows sometimes it is still not working properly.
if you dryer is gas check out this gas no heat tip....
If you have an electric dryer, you can have many different things that can go wrong causing the dryer not to heat.
check out this electric no heat tip...
heatman101
MY dryer wont dry all
It could be if you have it set on Auto dry the thermister is not working properly.But its much more likley the their is a clog or restriction in yor exhaus duct that is venting the dryer. Start by running the dryer and going outside and checking airflow should have agood flow of warm air,if not the entire system should be cleaned not just the flex hose behind unit.. You need good air circulation to dry the clothes properly thats what helps get rid of the moisture. If not what you end up with after one cycle is warm moist clothing..... Hope this Helps with your concern
My dryer wont start
this is common issue,,,thermofuse ,,home electricity check cercut breaker,,thermofuse is located normally behind the rear cover,,it is the only white fuse in the unit it is not resettable but is cheep to buy and easy to install,,,,,
www.myabcspace.com/washerwizzards
Dryer won heat timer dosen't avance
huntman, the model posted shows as a gas dryer. In the lower left side there is a square plastic peep hole. Take a putty knife and pull it off. Set the dryer to high heat and take a look in the hole. Does the ignitor glow? If it doesn't you either have a bad thermal fuse or a bad ignitor. Start with the thermal fuse. You will have to remove the back panel to get at it. I will attach a photo. You can ohm it out, or just jump the wires temp. to see if the ignitor glows. If theral fuse is good and the ignitor does glow, you probabley have a bad set of coils. These sit on the gas valve are easy to replace. The timer won't advance without the heat. Check this out first...Catriver..post back.
Not finding what you are looking for?