Mag Innovision InnoVision XJ 717 Monitor - Answered Questions & Fixed issues
Hey , i have Mag 900P monitor and i cant see
Hello there !
There could be a problem with the picture tube it could be dead( shorting) or the tube Transformer s damaged another course of this could be at the Horizontal section ie a Transistor or a Diode could be shorted .
Pls tell ur Technician to check all this .
Lastly Buy a new Monitor .
Good luck
I have a 32
its overheating or the lamp is bad, get some canned air and spray the inside with the air.
I'm trying to plug my sata hd into my esata DVR
What you can do is go to a good computer hardware store like, new egg. or somewhere that sells core hardware for computers. you should be able to buy a PCI-E or a PCI ESata card so you can plug it in. hope this helps!
Sony videoscope XBR - Side by Side screens can't change it back.
Sounds like your TV has a PIP (picture in picture) that allows your AVI (audio visual input) to be viewed simultaneously with your cable input. Check the manual for the correct buttons, but the one you're looking for says either PIP or AVI or something along those lines. Hope this helps
Recently been experiencing double vision on my tv
What you are seeing is the high frequency equivalent of an echo.
This is normally caused by external received signal problems rather than the set itself.
Note that one of the images is stronger than the other; this is the primary received signal.
The weaker one is occurring a few microseconds later and is being received as a reflection from a building or a poorly terminated cable.
Repositioning your antenna or replacing your cable will probably help a lot.
Desktop computer
It depends on what kind of programs he needs to work. I work with AutoCad 2008 and Google Sketch Up Pro Version 6 for my Architectural work on a low end PC. With a Pentium 4 @ 1.5 GHz, 512 MB RAM, and a small HDD, so you do not need much. Pretty much the cheapest new PC you can buy would be perfect. Hope I Helped!
Television
replace the horizontal transistor near the EHT.
Sony videoscope xbr
the problem is most likely to be found on the HOrizontal Output Transistors note their numbers and replace them.this transistors are usually mounted on huge heatsinks.
Sony Videoscope XBR
from experience i have noted that after some time the Horizontal Out-put Transistor (HOT)gets worn out.This is a big black transistor starting with cd,d,t etc mounted on a big heatsink.note the numbers and replace it.
Sony Videoscope XBR tv
This is usually a convergence problem.. Could you update this with the model number please. That will allow me to give you some specifics about what could be wrong and how to fix it.
Dan
My monitor was fine for
check the cable connected to the monitor
run another monitor on your pc and if it does the same , try installing a serarate graphics board and if you are already doing that, replace that graphic board
No sound on computer- MAG Innovision Model 468
Solution 1 It might have defaulted your sound button to mute Got to control panel Sound and see if sound has been muted
Solution 2 unplug jack out of plug at rear of computer test it in other jack holes what might have happened is that the default setting for speaker and mic might have swapped round best way is play some music and move jack plug around see if you get any sound
Solution 3 Sometimes the sound software needs re setting bring it up and re sett speekers and mike setting by the colours you have you jack in remember front and rear you will be mainly dealing with rear jack interface green pink blue white etc
hope this helps
Not finding what you are looking for?