20 Most Recent
Bazooka 4-Channel 240W Amplifier (BA460) Car Audio Amplifier - Page 6 Questions & Answers
Ford ranger 6500 audio system reset code,serial
When you disconnect your battery and then reconnect itagain, it disables the radio. This is an anti-theft protection for your carradio. The enable your radio the activation code is in your vehicle owner's manual. Ifyou do not have this code you need to go to your Ford servicecentre and get them to enter this code for you.
Is the official public feed of the Pay-Per-Click partner program. Keep in mind that they also transfer their personal data on request.
2003 nissan terrano 2 radio entry code process
Try this. Turn the ignition on, with the engine off. Turn on the radio. Press and hold button 4. The display should change. Use the Tuning buttons to enter the code. (I think its up/down to change the numbers). Enter the first number and press button 5 to confirm. Use the tuning buttons to move along to the next number, (i think it's left/right for this bit). Repeat the method for the first number, (Set number then press five to confirm). Once you enter the last digit the display should switch back to the normal display and be ready to use.
I recently purchase vehicle with
take your dvd player nearest electronis & electronic store he will gave u same matching code of your dvd payer its came prise of code is $5 to 20$
thnx using fixya
HYUNDAI GETZ 2006 MP3-03G STEREO
Radios have a theft-proof system that freezes the radio if
interrupted. It was designed that way to prevent theft of the radio. The
downside is your radio will be locked if you disconnect the
for any reason, or if the battery dies.
When you restore power, it will say ‘CODE
‘ on the
- When the radio displays CODE, you may enter the
code using the preset radio station buttons
- For instance, my number is 1615, so when I get the CODE
radio’s display, I press the radio preset button 1, then the radio
preset button 6, then the radio preset button 1, then the radio preset
- If your radio says OFF, leave the ignition on in the
for 2 1/2 to 3 hours in order for it to display CODE. In certain models
you can clear the OFF state by pulling the fuse for the radio (#7 in
my car). That’s a bit simpler than leaving the ignition in the first
position for a couple of hours — particularly if you don’t have a
garage. enter the code with the above procedure, if the problem still persist, am afraid you will need to take it to electronics repair workshop for diagnose, i advice you do not do it alone in other not to complicate issues.
Which setting is for ohms own a micront22-184meter
Do you mean a Micronta 22-184 multi-meter? The Ohms position is depicted by the Greek letter Omega. This is the third position from the right. The DC milliAmps setting is just to the right. See the picture here: https://www.ebay.com/p/12027907565.
I had to do the counter-intuitive decrease font/image size to enlarge third picture from the end to see the characters in the image.
I hope this helps.
Not finding what you are looking for?