20 Most Recent Behringer F-CONTROL AUDIO FCA202 External Sound System Questions & Answers


is there any support for windows 7 64 bit? my behringer model is fca 202?

Behringer... • Answered on Jun 02, 2019


The power supply for the FCA202 is rated for 12V DC at 200 mA. (The AC power adapter connects to 120V AC, 60 Hz in the US. The UK version is for 240V, 50Hz.) The specifications are on page 26 of the User's Manual: http://www.behringer.com/assets/FCA202_P0451_M_EN.pdf .Cindy Wells

Behringer... • Answered on Sep 16, 2014


Block diagram available here:
http://www.behringerdownload.de/XENYX_GRP2/1204FX_VIEW_Rev_A.pdf

Where are the trim controls set?
Those mics use both phantom and battery power; are the mic switches set to phantom?
Try using the CD/Tape outputs to the FCA202

Behringer... • Answered on Aug 19, 2014


Here is the linkHope this will help . . .Behringer F-CONTROL AUDIO FCA202 FireWire ASIO FIN Download Link: http://www.behringerdownload.de/UCONTROL/fca202_1.0.0.zip Supported OS: Windows XP / Windows Vista

Behringer... • Answered on Sep 13, 2013


BEHRINGER FCA202 - Driver version 1.3 for Windows XP (32-bit), Windows Vista (32-bit), and Windows 7 (32-bit) may be downloaded from the attached file. After downloading and decompressing ('unzipping') the download file with WinZip or other compatible utility, run the resulting .exe installer file to install the driver package.
http://behringer-en.custhelp.com/ci/fattach/get/44010/1269637577/session/L2F2LzEvdGltZS8xMzA0NzIyNDEzL3NpZC9VcGxZWWl0aw==
hope this helps

Behringer... • Answered on Sep 13, 2013


In my xvamp, a strucked microbutton caused E2. I've replaced the button, and everything went right :D

Behringer... • Answered on Dec 05, 2012


The hardest part will be disassembling the mixer. You must remove the side panels and the bottom (four screws each), all the knobs (50 of them), undo the nuts on the various 1/4" jacks (14), then finally remove the screws mounting the single circuit board (13). The power jack can be unsoldered and the leads from the power module can be solder to the same pads.
The power module is simply a center tapped transformer. There will be three wires corresponding to the three pins on the connector. The center tap has to be correct, but the other two are interchangeable.
Just remember to thread the cord through the hole in the chassis BEFORE you solder the wires down. And provide some form of strain relief so that pulling on the cord doesn't stress the circuit board.

Behringer... • Answered on Jul 09, 2012

Not finding what you are looking for?
Behringer F-CONTROL AUDIO FCA202 External Sound System Logo

81 questions posted

Ask a Question

Usually answered in minutes!

Top Behringer Computers & Internet Experts

Cindy Wells

Level 3 Expert

6253 Answers

Mike

Level 3 Expert

4374 Answers

ADMIN Canada
ADMIN Canada

Level 3 Expert

37431 Answers

Are you a Behringer Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Behringer Computers & Internet

  • Behringer Computers & Internet

Most Popular Question

need know voltage behringer power supply

  • Computers & Internet
Loading...