20 Most Recent
Denon AVR-3300 Receiver Questions & Answers
When I switch on my Denon AVR 3300 , only the ON / Standby light flashes and no display
Hi
Are you familiar with electronics?
If and/or when the red led light is flashing it means the device is in protection mode.
1: check voltage regulators 5v and 12v which are the important parts to keep the device operating.
2: if there is a short circuit on the power amp, meaning the power output of the receiver.
3: check output Transistors.
Hope this will help or you can give these to a technician that can help you.
Good Luck
Denon AVR3300 - Resetting activated Protection Circuit
Hi
Remove all speakers cables or wires and check all from behind the Receiver. if there are any loose terminals or any metal object in between the terminals.
though it might be a coincidence that you have a problem in the Receiver.
unplug the power cable from the wall socket and remove all cables.
after you remove the cables plug the power cable in the wall socket and try if you see the protection displayed , the receiver needs service.
Good Luck
Regards
Zone 2 volume problem
Zone 2 vol on the remote must be tirned up. vol is only controlled on the remote control
Buzz or hum
My guess would be +and -12v supply to preamp opamps has ripple. (drycaps or bad solder). I may be able to get you a pdf service manual if needed.
[email protected]
Not finding what you are looking for?