20 Most Recent Scotsman Ice Maker CM3 30inW Cubed Ice Machine 900LB - Page 6 Questions & Answers

I don't know the answer but you can go to the Scotsman website and they have manuals for their various machines. https://www.scotsman-ice.com/service/

Check your water filters, they might be clogged... water pressure is not sufficient.

Sounds like the refrigerant is not getting to the mold body to freeze the water. Probably low in the system . Requires a repairman.

try manufacturer or manualsonline.com

The cloudy look maybe very small air bubbles. To check this, draw a glass of "cloudy" water and let it stand for a while if after that the cloudy ness is gone then it was tiny air bubbles and harmless, if not then you got a bigger problem.

How to work on Scotsman Prodigy Ice Machine

Check your water supply. It may be filling too slowly.

replacing gear box on hoshizaki

if its an older model the last 2num

If your unit is making ice and is not shutting down on any faults then you need to check to make sure the condenser coil is not dirty or the air filter. also where is the machine located? If an ice machine is sitting in a warm to hot location then the slower it makes ice.The cooler the air around the unit entering the condenser coil the faster it will make ice.

Refrigerant migration nothing can be done.

Water pressure from city side should be. (Minimum 20 psi ) Maximum (80 psi ) If sump tray is filling up and water valve is cutting off then water supply is ok. If you are not getting enough water over the evaporator plate then you need to make sure the distribution tube is not stopped up with. if it is clear then replace the water pump.

First check to see if you have power to unit, Check beaker or fuse. Reset or replace , Restart and check with a voltage meter. If you have power to unit from wall then check to see if you have power to the controller, if you have no power to controller then likely cause: Transformer open. Solution: Replace transformer. Make sure there is power to the on/off switch and going through the switch to the controller, if you have power to switch but not through the switch when in the on position then replace switch. Check this first.

Partstown.com has a pdf down load manual.