20 Most Recent Hoover Nextra HNF 2137 Front Load Washer - Page 7 Questions & Answers

0helpful
1answer

Anyone know how to remove an Agitator from a Hoover 600MD washing machine I've undone the bolt at the bottom but it won't budge

sometimes they can seize on a couple of levers and gentle coaxing might get it
6/4/2018 3:04:51 AM • Hoover Washing... • Answered on Jun 04, 2018
0helpful
2answers

I have been given a

Have a look under the lid. The settings are set into the plastic.
Hope this is what you were looking for. Cheers
4/27/2018 12:19:26 PM • Hoover Washing... • Answered on Apr 27, 2018
0helpful
1answer

I have a Hoover washing machine and lock symbol is showing so it won't work how do I get it of

Try holding down the start button for a few seconds.
4/2/2018 8:07:03 PM • Hoover Washing... • Answered on Apr 02, 2018
0helpful
1answer

What does e16 mean please?

An E16 error code means there is a heater insulation problem which could cause the tripping of your fuse box and other random cycle errors, but it's hard to prove without the replacement of your heater. For more information on other error codes , watch this video . http://www.espares.co.uk/advice/0/2531/how-to-understand-hoover-and-candy-washing-machine-error-codes
3/13/2018 2:42:26 AM • Hoover Washing... • Answered on Mar 13, 2018
0helpful
1answer

Following freeze, water is gushing underneath hoover washing machine when mains turned on.

You'll need to tilt it or remove the back or pop the top to see where the leak is coming from. Unplug it first. I had my water pump crack and leaked. It was a plastic part not related to freezing though, and it only leaked when it ran a cycle. Perhaps your leak is prior to the water pump.
3/12/2018 10:37:37 PM • Hoover Washing... • Answered on Mar 12, 2018
0helpful
1answer

I just opened my washing machine door after finishing a wash and there was smoke coming out of the door and a smell of burning. It is a Hoover model no HWB814D-80S.

Was the burning a burned rubber smell? Maybe its your belt. either off track or worn down and motor is spinning but the belt is not turning. Just something to check.
3/12/2018 3:19:12 AM • Hoover Washing... • Answered on Mar 12, 2018
0helpful
1answer

I have hoover Optima wmh139 with lights flashing from left to right it's 1 2 5 how do you read fault

here are what the numbers mean. 5 is probably throwing the others but you'll need a service tech to know for sure. have you unplugged/cut off power to it for 10 min to see if it may possibly reset? Worth a try anyway. Error 1 Door safety lock error
  • Check door is closed and latched correctly
  • Check wiring
  • Check door lock
  • Check drum braking device if fitted
Error 2 Not filled in preset time allowed - washing machine does not fill
  • Check mains water pressure
  • Check inlet hoses for kinks
  • Check inlet filter
  • Check water inlet valve
  • Pressure switch fault
  • Wiring fault
Error 3 Not drained in time allowed - washing machine fails to drain water
  • Check that filter is not blocked or obstructed
  • Check drain hose is clear of any blockage or obstruction
  • Check wiring to drain pump
  • Check drain pump is not defective
  • Check level sensor or switch
  • Check wiring to level sensor
Error 4 Multiple instances of anti-flood contacts in pressure switch being made
  • Check for overfoaming evidence - can trip pressure switch
  • Check wiring to level sensor
  • Check pressure switch is not defective
  • Water inlet valve locked open
Error 5 NTC fault - temperature sensor detected as either open circuit or shorted
  • Check wiring to temperature sensor
  • Check thermistor
Error 6 EEPROM failure - defective electronic controller
  • Check wiring
  • Check electronic control PCB
Error 7 Motor fault detected
  • Check motor connector block
  • Check wiring
  • Check motor carbon brushes
  • Check tacho connections
  • Check motor
Error 8 Motor tacho fault - washing machine motor tacho detected as open circuit or shorted
  • Check motor connector block
  • Check wiring
  • Check tacho connections
  • Check motor
Error 9 Short circuit motor triac on electronic module
  • Check wiring
  • Check electronic controller
Error 12 Communication error between electronic control boards and wiring
  • Check wiring and harness between control boards
  • Check electronic control modules
Error 13 Communication error between boards and wiring
  • Check wiring and harness between control boards
  • Check electronic control modules
Error 14 Water heating error detected
  • Check wiring to wash heater and thermostats
  • Check wash heater for continuity
  • Check NTC (temperature sensor) probe
Error 15 Defective control module - Not programmed Cuore control
  • Reprogram electronic controller
  • Replace electronic controller
Error 16 Water heating element detected as short circuit
  • Check for defective electrical insulation
  • Check water heating element
  • Check water heater wiring
Error 17 Wrong signal from motor tachometric generator
  • Check motor connector block
  • Check wiring
  • Check tacho connections
  • Check motor
Error 18 Defective control module - also can be wrong electrical input frequency
  • Check wiring to electronic controller or both if two used
  • Check electrical input frequency
  • Check mains electrical supply
2/26/2018 6:38:33 PM • Hoover Washing... • Answered on Feb 26, 2018
Not finding what you are looking for?
Hoover Nextra HNF 2137 Front Load Washer Logo

51 questions posted

Ask a Question

Usually answered in minutes!

Top Hoover Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1482 Answers

Oloyede Monsuru

Level 3 Expert

1468 Answers

Sheldon Dedek

Level 3 Expert

912 Answers

Are you a Hoover Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Hoover Washing Machines

  • Hoover Washing Machines

Most Popular Question

machine wont sart

  • Washing Machines
Loading...