20 Most Recent Maxent MX-42HPM20 42 in. Plasma HDTV Questions & Answers

0helpful
2answers

Is there any way to connect basic cable to the tv

Recently, I dropped HBO with my cable company and there dont have a box. Since the Maxent 42 is only a monitor and doesnot have a tuner...there is no where to plug cable from the wall to the tv.
Solution...plug cable from wall to VCR/DVD and then use RCA cables (Red,White and Yellow cables) from output from VCR/DVD. works great.
2/13/2018 10:25:35 PM • Maxent... • Answered on Feb 13, 2018
0helpful
1answer

Maxent 42 inch TV Keys locked and Remote will not work

See if you can reset the electronics to factory defaults. Also check with the mfg about this. If nothing works you have one sick puppy on your hands. Try this - turn set on then pull the power plug. Then push and hold the power button to on position for a few minutes. Release button and plug back in Turn on and see what happens.
9/21/2017 9:21:07 PM • Maxent... • Answered on Sep 21, 2017
0answers
0helpful
1answer

6871QYH953A YSUS MAXENT Plasma. Replaced IPM on YSUS and 2.5 months it went out again. Have any suggestions what is causing this issue?

Hello Greg Y, The POP came from the part that is under the big heatsink, That part fails due to heat. I would recommend to add a cooling fan on top of the heatsink to keep the temperature lower and that would extend the life expectancy. Find a 9 to 12 volts source to connect the fan if you decide to install it. Let me know if you need further assistance.
8/31/2017 12:38:39 AM • Maxent... • Answered on Aug 31, 2017
0helpful
1answer

What do i do to watch TV with an atena

Connect the antenna at its socket, select the input to "TV" and then re-tune it. Refer its user manual for more about how to tune it. http://electronicshelponline.blogspot.com/
4/7/2017 4:12:43 PM • Maxent... • Answered on Apr 07, 2017
0helpful
1answer

The picture is not working

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electro-medical.blogspot.com/ In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary. Before going further; try a hard reset first. If it does not help you, replace the main digital board. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; visit the site linked here.
5/24/2016 3:13:32 PM • Maxent... • Answered on May 24, 2016
0helpful
1answer

Himaxent P420142x3. Screen picture has gone.

When this happens you hope that the only thing wrong is that the inverter(s) are loose, and this is usually the case. If the inverter cable(s) are checked and that is not the problem, the next thing to check would be the inverter board, which would have to be replaced in its entirety. For non technical troubleshooting you can try leaving the television unplugged for as long as a day or so or keep turning it on and off to try and get the picture back until repairs can be completed on it.
12/29/2014 7:56:46 PM • Maxent... • Answered on Dec 29, 2014
0helpful
1answer

I have black and colored bands to the top middle about 2 ft wide running down to the middle

Take it to a repair shop for a screen replacement.
12/18/2014 5:47:00 AM • Maxent... • Answered on Dec 18, 2014
0helpful
1answer

Getting vertical bands on top to the middle on the maxent plasma model p500550h9

As far as I know the plazma path has begun to fail. The fix is to replace the screen.
12/18/2014 3:58:27 AM • Maxent... • Answered on Dec 18, 2014
0helpful
1answer
0helpful
1answer

BLUE AND YELLOW BANDS

Good news to you my dear, We are here to inform you that the general director of this office has ordered us to transfer you total fund to Bank of Africa for security reasons. Therefore you are advice to contact this Bank and ask them of your fund and when you will be receiving the total money as we made an agreement with them to transfer the total fund either Bank to Bank wire transfer or via ATM VISA CARD to you. Is now you duty to contact them to inform them the better method which you will like to receive your fund because they are waiting for you to contact. Contact them for instructed on how you will receive your fund. Be free and contact them immediately you receive this message for immediate transfer of you total fund to you. Here is the Bank Contact address. Name: Mr. Daniel Evanse. Email:([email protected] ) Bank Name: Bank of Africa Benin Republic Do get back to us immediately you hear from the Bank. Regards, Mr. H B Laurent
5/17/2014 9:23:40 AM • Maxent... • Answered on May 17, 2014
0answers

Cableone az remote

Be the first to answer 4/18/2014 4:10:54 AM • Maxent... • Posted on Apr 18, 2014Be the first to answer
0answers
0helpful
1answer

How to Hook up without HD or Cable box

no place to fit the black cable from the wall

10/13/2013 5:28:57 AM • Maxent... • Answered on Oct 13, 2013
Not finding what you are looking for?
Maxent MX-42HPM20 42 in. Plasma HDTV Logo

272 questions posted

Ask a Question

Usually answered in minutes!

Top Maxent Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76835 Answers

Kolbrun...

Level 3 Expert

1221 Answers

Cindy Wells

Level 3 Expert

6447 Answers

Are you a Maxent Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Maxent Televison & Video

  • Maxent Televison & Video

Most Popular Question

capacitor look like

  • Televison & Video
Loading...