Top 20 Reddy Heater-170,000 BTU Kerosene Deluxe - Page 9 Questions & Answers


CIRCUIT CARD-
-Photocell blue wired go to two terminals marked BLUE PHOTOCELL (any order)
-Motor red wire plugs onto terminal marked MTR MAIN, motor white wire plugs into terminal marked WHITE MOTOR.
-potentiometer (thing with knob) two white wires plug into terminals marked TEMP SEL
-Black wire from switch to terminal marked L1 BLACK
-White wire from power cord goes to terminal marked N White
-Ignitor (used to be yellow wires) goto terminals marked IGNITOR and IGNITOR RET (any order)

OTHER-
-White wire from power cord goes to switch terminal marked 3A , other pigtail of the white wire goes to board as described above.
-Black wire from power cord goes to swtich terminal marked 4B

Reddy... | 656 views | 0 helpful votes


Time for a full servce overhaul - kit at your lawnmower supply house.

Reddy... | 259 views | 0 helpful votes


probably both and unburnt fuel also. when the unit ran out it still pumped a small quantity of fuel into the hot burner chamber where it turned to smoke and was expelled. carbon monoxide itself is odorless and what is normally referred to as c. o. odor are unburnt fuel products, some of which smell pretty strange.

Reddy... | 115 views | 0 helpful votes


Remove the top cover. There is an ignitor that glows at start up. Look to see if yours is functioning. They break easily and yours could be bad.
Troubleshooting tips

Reddy... | 308 views | 0 helpful votes


Cuts on and goes right back off

Reddy... | 241 views | 3 helpful votes


You don't say, but I am assuming that the motor is running and there is combustion in the combustion chamber and the heater is running fine, then the reset trips. Is this correct? If so, chances are the Safety Control (reset) is defective. Part number HA3003. The photocell could also be at fault. Check for a dirty lense on the photocell.

But---If there is no combustion in the chamber, then the photocell detects a no-flame condition and then it trips the reset.

Troubleshooting tips for a Spark Plug type heater

Reddy... | 497 views | 1 helpful votes


Adjust air flow ratio screw on back of blower motor.

Reddy... | 103 views | 1 helpful votes


Photo eye needs adjusted.

Reddy... | 108 views | 0 helpful votes


www.desatech.com/centers.asp?title=kerosene+heaters&brand=reddy+heater

www.robinrents.com/heaterparts.htm

Try those 2 sites. Apparently it is a problem getting info on them from Toro, who bought Lawnboy, but chances are good that the machine was made by Desa for LB. If you need parts, you may try a place like Farm and Fleet if you are in the midwest, or a similar farm/home store.

Reddy... | 258 views | 0 helpful votes


Ace Hardware usually has parts for most models including igniters - call first try the one in Conway its not far from you

Reddy... | 109 views | 0 helpful votes


I have a 125t and the igniter works,it is getting fuel and still won't lite. Can you help?

Reddy... | 501 views | 0 helpful votes


its getting air in the fuel or the pump is pluged,remove the back and you will see a square box with lines going to it,it is best to replace it,I hope this help you and have a merry x mas

Reddy... | 143 views | 0 helpful votes


Tue up kit from your local lawnmower supply house.

Reddy... | 140 views | 0 helpful votes


you need to go to a place that sells this product,we help with repairs here

Reddy... | 108 views | 0 helpful votes


The ignitor wire must be grounding against the cover. Check wire for breaks or bare spots.

Reddy... | 134 views | 0 helpful votes


all heaters have safety swithches and should not be bypassed. it sounds like the fan is not putting enough air over the heat exchanger on this heater and a high limit switch is shutting it down. I would go to there website and with the model and serial number and get an exact replacement motor for it. This should be much cheaper than replacint the heater.

Reddy... | 219 views | 0 helpful votes


either the pump has a broken vane, or motor bearing is frozen up. check for free rotation with power cord unplugged.

Reddy... | 66 views | 0 helpful votes


on the ack of the motor/pump assembly there is a small plug with a hole in it. inside this plug are a spring and a small ball. turning this plug in or out offers some pressure adjustment.

Reddy... | 58 views | 0 helpful votes


Clean the lens of the photocell - electric eye- Check pump pressure on back of motor at pipe plug

Reddy... | 274 views | 0 helpful votes

Not finding what you are looking for?
Reddy Heater-170,000 BTU Kerosene Deluxe Logo

389 questions posted

Ask a Question

Usually answered in minutes!

Top Reddy Heating & Cooling Experts

Paul Carew

Level 3 Expert

3527 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Fahr Quad

Level 3 Expert

774 Answers

Are you a Reddy Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Reddy Heating & Cooling

  • Reddy Heating & Cooling

Most Popular Question

stupidly filled kerosine diesel heater

  • Heating & Cooling
Loading...