20 Most Recent
Brother MFC 7420 All-In-One Laser Printer - Page 7 Questions & Answers
Toner life end
1) Pull out the cartridge and look on the right side of the it. You will see a small hole that has a glass like window in side (round window).2) Turn off MFC-74203) Cover the hole on cartridge with a duct or a piece of paper. Basically block.4) Replace the cartride back in the printer and turn on the printer. 5) The message should be gone and you should be able to use the copier functionality
I can't figure out how to hook up the fax
take the phone cod from the wall and plug it directly to the back of the machine where it's written LINE. And if you want to also receive phone calls, you can run a cable from the EXT. port straight to your telephone
I had a paper jam
The switch/sensor or actuator for the rear door may be damaged or out of place.The switch is located on the High Voltage Power Supply (Part# WH773). Iteminc.com has this part in stock and can ship same day. The sensor which reads if the door is open can go bad and it is part of the HVPS. Here is a video that explains this error and shows you how to replace it. This will fix this problem 90% of the time, just make sure you set the HVPS correctly on TOP of the actuator (plastic piece that hits the switch). If for some reason this does not work, check that the actuator is not broken and try reseating the HVPS and try again. Hope this helps. Good luck!
When I use the printer to scan via the document
Open the scanner cover and you will see two glasses. One long and thin and the other larger than an A4 sheet of paper. The long thin glass is used to scan thru the adf and the larger glass is for flatbed scanning.
As your lines are from the adf scanning, you will see tippex on the long thin glass. just clean it off and all will be well. Clean the flatbed glass as well while you are doing the job on the adf glass.
ISO28-setupfaxprinterdriver-1
Hi,
You can go to this website to download the specific driver for your device. Make sure to download all available updates as well. Follow the installation procedure and post here if you have any questions.
Hope this helps.
My MFC-7420 keeps powering off
Yes you have a failing power supply board in the printer. When it comes to faults like this it is better for safety's sake to take it to a brother repairer.
Not finding what you are looking for?