20 Most Recent
Questions & Answers
The door is locked on my hotpoint wf430
the best thing you can do is remove the power lead the take the top panel off and push the drum to the rear and using a small screwdriver remove the lock and replace it from the manufactures website (you can switch off the machine at anytime and restart it by turning it back on and pressing start again depending on the type of machine of course) eric
How to take of front panel and side panel to get at drum
Take of top cover, remove top front panel. Remove front, two screws top front, two screws bottom front, loosen the doorlock and door bellow. Disconnect everything on the drum, (motor, dampers, heater, water pressure switch hose ect. Lift the drum out. Good luck.
Door locked no light to say locked no washing
Brusheson motor will be worn. The door lock is in series with the motor so if brushes worn it interrupts the signal telling the board the door is locked. New brushes will likely be all it needs.
HOW DO I FIT NEW BELT TO HOTPOINT WF430 WASHING MACHINE
The easyest way to fit these belts is to locate it on the motor pulley
and as far onto the right hand side of the main pulley (viewed from the
front of the machine) as possible. Hold it on the main pulley with a
cable tie and rotate the drum anti clockwise by turning it from inside.
The belt will be drawn onto the pulley and the cable tie will snap as
it rotates. (Easy)
Not finding what you are looking for?