20 Most Recent Hotpoint WMA35 Front Load Washer - Page 7 Questions & Answers

If the machine has taken in water, and not drained it out. it will prevent the door from opening. Have you tried draining the machine, and then trying to open the door?? The easiest way it to either set the machine on a slow spin cycle, and allow it to finish that, or if your particular machine has a "drain cycle" ( this feature is not on all models) set the machine to drain, and when it has finished, try opening the door. I hope this helps?

see link https://www.hotpointservice.co.uk/washing-machine-repair/error-codes

Switch it off from switch on the wall , let it stay off for a minute or two then switch it back on , this should reset it.

New belts fit vary tight. You probably have the right one. It takes a lot of force to stretch it in place. Ask someone else to do it for you.

It sounds like an over temp sensor is tripping.....Make sure the lint filter is clean and no lint is blocking the vent pipe.........A fire hazard is present so be careful......Unplug the Unit while servicing the vent piping...........

It depends on the reason for the hot smell - discovering this would mean a trip to the service shop and weighing the cost of that against a replacement microwave. Unless your Hotpoint is something special, it is likely a replacement would make sense. It is wise to periodically measure the power output of a microwave oven by timing the boiling of a measured quantity of water when it is young. When or if the time has extended more than about 10% it is time to think about service or replacement. It is also important to keep the inside of the cabinet clean and all the air vents clear.

• F05 - Pressure switch jammed on full
• Thing to do check pump is not blocked and clear it then reset machine by unplugging for 5 mins and plug back in if still gets error F 05 then you need a repair call out. hope this helps.

Using your belt, slip it under the agitator. Give a very hard yank and the agitator will pop up and off. DO NOT HAVE YOUR FACE OVER THE AGITATOR WHEN YOU PULL ON IT. It can pop up with force, and end up breaking your nose! So be careful!

Has it got a "reset"button? If not you could of damaged the circuit board

hi there, check out page 13 toward the bottom https://www.manualslib.com/manual/71053/Hotpoint-Wml-540-P-G-A-K.html?page=13#manual good luck

If your washing machine does not turn on lights or make noises, it probably has come to an end. You have correctly performed the necessary tests. Now I recommend that you request the services of a specialist. You will save time and money. Believe me.

http://www.fixya.com/support/t142348-fdw60_flashing_eco_light_error

I noticed the washed dose this if I run a bath sounds daft but it's like it's not getting enough water feed whilst I'm using water else where and once my bath turns off error message goes away

Is it pumping water out?

The Hotpoint error code F03-is a temperature sensor fault This could be due to the heating element not coming on.

You may think u have checked all but underneath there is a black soft rubber hose and sometimes a sock can get sucked into this and stops draining worth a try if not maybe your pump is gone

Remove the hose to the sensor switch at the tub end and check for obstruction. The small container on the side of the tub may be clogged. Clean with a small drill or piece of wire.

https://manualzz.com/doc/2057104/hotpoint-vtd-6000-clothes-dryer-user-manual Here's your diaGRAM