20 Most Recent
Hotpoint RFA60 Bottom Freezer Refrigerator - Page 10 Questions & Answers
Hotpoint Future fridge freezer - freezer working well but top of the back of the fridge has a large build up of ice ??? And doesn't appear to be keeping the food cold enough
here are lots of things that can cause cooling problems. One of the most common causes of poor cooling in a frost free refrigerator is a defrost system failure. In such a case one or the other compartment may appear to be keeping proper temperature but that too may change in a short period of time. The fridge compartment's temperature rise is usually (but not always) the first to be noticed. Frost" and "Ice"
There is a difference between "frost" (a white, snow-like substance) and "ice" (usually clear and solid). When referring to what is seen during an inspection, please keep this distinction in mind as the possible causes for each are often very different. The Defrost System
Inspecting the (usually rear) wall of the freezer compartment for a frost build up is necessary. (In the case of many GE top freezer models, check the freezer's bottom panel.) If there is a frost coating on it, it is often a sign of excessive frosting beneath it. Sometimes however the evaporator cover panel will actually need to be removed (see the illustration below) before an excessive frost build will visible.
The refrigeration system's evaporator (cooling) coil is usually in the freezer compartment. This evaporator will periodically frost over and have to be defrosted by means of a heating system. When the defrost heating system fails, the frost can accumulate to such a degree that airflow throughout the appliance is hampered. There may be just enough air circulation to cool the freezer section but that will eventually stop too.
9/28/2016 6:33:42 PM •
Hotpoint...
•
Answered
on Sep 28, 2016
Hotpoint icemaker works after doing the test cycle but quits after the one cycle.
Measure the temperature in your freezer- it should hover between 0-10 degrees F... Most icemakers require less than 13 degrees F to satisfy their internal thermostat. Water and most foods freeze at 32 degrees F, so if your machine is running somewhere in-between those two temp ranges, your icemaker will exhibit the symptoms you describe... If your temperature is steadily low enough, but the unit won't cycle on it's own, you will have to buy a new icemaker.
GE Ice Maker Assembly IM6D This kit is great because it comes with a "free" water valve and only costs a few bucks more than a kit with no valve...you decide!
7/6/2016 3:00:40 PM •
Hotpoint...
•
Answered
on Jul 06, 2016
How do I stop a red flashing light on a fz175 hotpoint freezer
Unplug it - but I don't recommend that.
The flashing light indicates that it is working - and you can see it from a distance. Saves walking down the stairs to open the door of the freezer in the basement.
Worry about your freezer if the light goes OUT.
Good Luck
If this was helpful, please rate accordingly.
Thanks.
7/4/2016 1:44:16 PM •
Hotpoint...
•
Answered
on Jul 04, 2016
I have a frost free hotpoint and theres ice on the freezer door and the food inside it what could this be and how,do i fix it
Hallo
Frost free means there is an evaporater coil behind the backplate of the inside of your fridge.
How it works is a fan is for example installed in the lower back of your fridge and the evaporater above the fan covered by a plastic cover/steel plate and now the fan is pulling the warm air from the top over the evaporater ( the evaporater is then pulling the warm air into the evaporater without increasing the temperature of the evaporater) and dehumidify at the same time and blowing the cold air out a the bottom of the backplate while the warm air moving to the top where it could repeatedly repeat this action.
Tell me what is the condition of your freezers door seal? It can only be caused by humidity getting in so it mean the door is not sealing 100%.
Regards
6/9/2016 10:09:29 PM •
Hotpoint...
•
Answered
on Jun 09, 2016
Hotpoint ice diamond RFA52 P freezer ok fridge not cold enough, this is not a frost free and there are no vents in fridge or feezer?
Good day, please check at the back, at the bottom where the compressor is located for the pencil dryer(as in photo). Get a nice firm grip on it just be careful and feel the temp if it's cold or one side is hot and the other side cold the dryer is block. Otherwise feel the thickest pipe running into the compressor it should be cold if the fridge has been running for a while and the thin copper pipe existing the compressor should be hot. If the thin pipe is freezing up with a thick layer of ice and the dryer as some med-temp then there's a gas leak. If the thin copper pipe is very hot and the dryer has no temp then there's a blockage but if the thin copper pipe feels med-temp and the thick copper pipe more or less the same but a bit cooler the compressor is not pumping also feel if the compressor is running. If dryer as a warmth temp and the thin copper pipe is hot and the thick one very cold(when tipping your finger on your tongue and pressing it against the pipe your finger should stick a bit) if all checks out then it's the thermostat switching the compressor off at the rong temp.
Regards
6/9/2016 8:03:05 PM •
Hotpoint...
•
Answered
on Jun 09, 2016
Not finding what you are looking for?