20 Most Recent Jensen Fpc Cable Vm9114, Vm9213, Vm9214, Vm9412, Vm9512, Vm9313, Uv9,uv10 - Page 9 Questions & Answers

Try formatting ur USB stick to fat32 before copying anything on it. After formatting copy whatever ur trying to play. If it still don't play check the file compatibility of the unit. If your trying to play a mkv file and ur unit isn't compatible it won't read either. Hope this helps...

Your not getting enough power to your amp and this will damage them for sure! Also your amp needs to have it's own separate wire that goes directly from your battery to the amp! If you run your power wire for your amp any other way you are asking for major electrical problems. You need to have a piece of 8 Ga. wire running from your battery all the way to your amp, also need to have a very good ground very clean and making contact fully through another piece of wire the same size as the + wire from your battery! This is so important that you do this simply because if the wire is too small it will get hot from the current draw by your amps that it will eventually melt the jacket off of the wire and short out or even catch on fire! That sound your hearing is the amps cycling through power up and shutting down since they need 12 Volts of constant voltage and a constant source of current flowing through the wire it will start to power up but once both amps draw from the wire they loose the power needed to stay working, then they do it again, etc... Rewire your amps with large enough wire or if you are using the correct wire then I would suggest checking your battery and then your alternator for problems of under voltage. Hope this helps, always make sure to place a fuse in line from you battery + terminal no further than 18" from the connection to you battery and use a fuse that is rated for the WIRE being used. Your trying to keep the wire from burning up that's all that the fuse is for. The fuses on the amps are to keep your amps from burning up they are not protecting that wire at all.

check your antenna wire is plugged in securely. if its just scaning it is not finding a single.

you need a receiver for it.

try the setting menu. or what are you trying to do? a surround sound?

Ebay would be the best place to look...

how to power on the amp on my flip out headunit

You need to trick it into thinking you're in park. If you post the model the directions can be specific. There should be a signal line from your head unit to connect to the brake. You can hook a $2 toggle switch up under the dashboard, or hook up an auto relay between the head unit power line and brake signal line.