20 Most Recent Hayward Pool Products Aqua Pod Questions & Answers

Why is our Hayward system is saying clorinater turn off high temp

the VSP error is a code from the pump and not the controller or control system. the only way to clear this is to turn the breaker for the pump off for about 30 seconds to allow the electronics to reset.

Check bateries on control panel. Next check the relay. Batteries in hand held too.

what type the heater is communicating to aqualogic control is RAYPAK digital 2100 ? also go to outside where the aqualogic control is and look for diagnostic in control look for water temperature sensor connecedt to aqualogic and see what that say,

If it's a hairline crack just patch from the outside. Use an epoxy glue. I've done the same with copper fittings. Works like a charm.

Hayward is junk. Go with something else.

You can as long as you don't exceed the power specs for the controller.

https://www.hayward-pool.com/pdf/manuals/ProGrid-DExx20.pdf The best I could find was the manual for the DE4820. Other than the slight body differences, the 2 are not much different. Most of the parts are identical.

turn the valves so ALL the water goes through the heater and back to the pool