20 Most Recent
Questions & Answers
64 bit driver for windows 7
You could try a driver from a different HP inkjet printer that does have a 64 bit driver. But it maybe time to upgrade to a new printer.
My HP DeskJet 920c prints pink instead of blue, new cartridge has been cleaned and blue is visible on swab.
Try running multiple "head cleanings" on it, or you might have the cartridge in the wrong location (if thats possible on that model). If not, then the interface board on the printhead may be faulty or the ribbon cable the sends the signal to the printhead assembly. Most of the InkJet printers made now days are considered disposable electronics by the manufactures. Due to the low price point and the lack of parts support or cost of labor to repair when they do stop working right. Good Luck
Disassemble hp 920c printer
This printer having inter locking system, you cannot find any screws for opening.You can observe there is gap adges of covers, inser tool/flat screw driver for opening the covers of left,right & top/back(both combined)you can observe right back side small power supply container.
This printer having inter locking system, you cannot find any screws for opening.You can observe there is gap adges of covers, inser tool/flat screw driver for opening the covers of left,right & top/back(both combined)you can observe right back side small power supply container, detach power out socket, take out, only one screw fitted at the center point of the power supply & its covered by specification stikker, find the screw, open it... check for component failure.. best of luck
What do the three lights on the top right of the 920c HP printer indicate?
Hi,The first light (from left to right) is the Print Cartridge Status.This will flash if one or more of the ink cartridges are low or the cartridge incorrectly inserted. Also flashes if the wrong type of cartridge inserted.If the ink is low the light will stop flashing when you open the top cover of the printer.The second light is the Resume Light.This will flsh when anaction isequired such s loading paper or clearing a paper jam.The third light is the Power light.This will flash green when the printer is printing.Hope this helps you. Thanks for using FixYa.
Hi I have just put in ink cartridges and the reg
Hello and Welcome to FixYa!
Sir/Ma'am If the Check Print Cartridge message is shown and Red Light Flashing then it means that Either ink Cartridge is not installed properly or the function for detecting the ink level is disabled. For it Make sure that you install ink cartridges at correct position as indicated by the label on the print head holder. Press push mark until ink cartridge click into the place.
If you are sure then you have installed ink cartridge properly then try following to stop the flashing of red Light.
Now Turn On the printer, Mostly this issue is resolved by this, But if still you get the message and red light still flash then surely its an issue of Ink Cartridge, your ink Cartridge is defective, You need to change the ink cartridge, Your problem will be solved.I hope this solution helps you.Don't hesitate to let me know if you still have some confusion in your mind.Please Rate my solution as "Maximum Stars" and then give your Words of Appreciation as a Feedback.Thank you Sir/Ma'am for taking my service and fir using FixYaConcerned: Muhammad Uzair Team : FixYa
- Lift the lid to the printer (cartridges are on the right side.)
- Turn the printer off, then power it on again.
- Unplug the power cable from the back of the printer when the grinding noise starts.
- Move the carriage towards the middle of the printer (this procedure may take a couple of tries to get the timing correct.)
- Take out the cartridges and close the top cover.
- Reconnect the power cord. The power and the resume lights (green and red) should be on.
- Open the top cover, reinstall the cartridges, and close the top cover.
Not finding what you are looking for?