20 Most Recent HP LaserJet IIIp Printer - Page 8 Questions & Answers

data send and receive error. clear all print command

see the power connector side

toner not support or PCR not proper installed

you replace toner cartridge

Likely you replaced the formatter with a non-duplexing formatter. HP may be able to create a fix file for you but you would need to contact customer support and they will likely charge you for the service.

Hi Chimezie, If you are looking the the drivers for this model, you may download them from here: HP Color LaserJet 4730 Multifunction Printer

Which HP Laserjet do you have?

Look online for refill kits. There are many to choose from

Two possible answers immediately come to mind. You may be in economy mode which uses far less toner but often produces "washed" out looking pages. Also you may be out of toner or need to "shake" the toner cartridges. On my Samsung laser printer if I do not print for a week then I need to shake the toner cartridge gently to loosed the toner.

Please note the link below for the service manual. http://www.lbrty.com/tech/Manuals_HP/M175sm.pdf Please take caution and follow the directions carefully. I also recommend that you take pictures for each step so that you have a visual record of the process.

Only HP Authorized service centre can repair this. Get an estimate before you proceed. May be a costly component. It may be cheaper to buy a new printer than repair.

did you remove the barrier strip when you installed it? That can cause that but would normally trip an error on newer printers. Just because cartridge is new does not mean it cannot be defective,especially if you are using a 3rd party or reman cartridge.

If you have reused an IP address from an old or different printer then likely you have a stale print job that is spooling to the printer once you connect it and likely the driver is not compatible with the 2035. Try connecting the printer with a different address to see what happens.

I hope this help. Hp Error Code 52 Service Errors 52 Scanner Printer Repair Fuser

When it start to peint blank pages ? after change toner ?

Power the printer off. Clear the print queue. Power printer back on. And print something easy, like an email. If that works, try printing the page that caused the error. If the 49 comes back, it's that document. Do what Deepak says.

You don't say specifically what printer you have (other than, presumably, an HP.) Is it always happening, or happening with specific print jobs? SOME HP printers will let you increase the amount of memory in them. Some have a setting in their driver that doesn't always match your installed memory - for instance, you may have 512 Mb but it thinks you only have 96 Mb. Short term, turn off the printer, wait, turn it back on, see if it will print.

you need to make sure that your printer is supported by TWIN , you can do that online.

Go to the Menu, Settings, network, Wi-Fi and under the menu navigate to see the SSID the printer is connected to. Regards, Mike